Heatrae Sadia 95605869/95605021 Cold Water Combination Valve (Megaflo/Megaflow)

I bought this as a replacement for the earlier design of Megaflo 95605021 which my plumber had fitted several years ago, but which had started to leak slowly through the plastic pressure valve housing.That old version of the 95605021 had a second side outlet which the new version does not have (tho this dual product does), while the new centre joint makes it much easier to position the shut-off valve and the plastic pressure valve housing each in their best orientation.Good service from Unvented Components Europe too, recovering quickly and friendlily after an initial mix-up.

Boiler heating for water throughout my house, previous component had lasted around 15 years. Plumber recommended this replacement part and before I knew it, I had nice warm/hot running water again. Workmanship and quality second to none.

Had a leaking old pressure reduction valve Heatrae Sadia 95605869 and wanted to replace it but keep using the pressure relief valve. I Looking at the image of this valve, I saw there is a port oppose to the pressure reduction valve which in my old combination valve is for the 8 bar pressure relief valve. I took granted this product can just replace my leaking unit. However, when I took the old combination valve apart, I can see the fitting of the Haetrae Sandia pressure relive valve is the one using rubber o-ring while this newly ordered has all ports in 22 mm compression format. I searched Amazon for a matching 8 bar relief valve but there seem no one can fit the 22 mm compression port. You really need substantial plumbing work to reconnect this replacing valve with the pressure relief valve.regret. I would have spend 90 pound for those with pressure relief valve included to save amount of time and work.The valve itself looks in good quality and works well, so give 4 stars.

Perfect replacement for my old one. Smaller profile which is great as there is not a lot of space where it is fitted. Did it myself and saved about £200!

This is a perfect replacement for the heat Ray sadia valve. The third port is for the pressure release valve. Worked a treat

Plumber fitted this for me and advised that the shutoff valve did not fully shut off, so air gap could not be regenerated in the cylinder. He had to fit another valve in addition. Not much point in attempting a return as would have to re-fit the old leaking valve and get the plumber back again at additional expense. Probably a one-off, and although £100 cheaper than one from the plumber's merchants a bit disappointed that it didn't work properly.

Item arrived on time and as described

This replacement was exactly what I needed. The original Valve was not suitable and was returned.