ARTILAURA Marine Fuel Sending Unit Boat Fuel Tank Sender, 240-33ohms 11" (275mm) Stainless Steel Gas Sensor Water Fuel Gauge Sender for Boat Car Truck Vehicle

Bought this to replace a cheaper gauge that did not work. Fit well and easy to install. Works as advertised. Wish it came with a button switch to control color but I will add that later.

The sending unit went right in and was a perfect fit. It was alot easier to install than the original armature style.

Easy to install works great! And Affordable

The products are nicely made and look excellent.My biggest question - which never really got a straight answer except for ONE person who responded - was what kind of resolution the sending unit would provide to the gauge. The CORRECT answer is 1/4 tank increments or 5 positions.The gauge will read FULL when the tank is full.The gauge will read 3/4 when the tank is between 3/4 and Full.The gauge will read 1/2 when the tank is between 1/2 and 3/4.The gauge will read 1/4 when the tank is between 1/4 and 1/2.The gauge will read Empty when the tank is between E and 1/4.That's it. 5 dial positions only.Regardless of what the gauge dial shows as increments or divisions the sending unit tells it what to display. This is NOT and analog sending unit that will signal an infinite number of tank levels meaning the gauge will jump between quarter tank marks not move smoothly and display any increment between them.Don't believe what people say in the Q & A. Believe actual results.As an aside note, take the capacity of your tank, say 20gal for instance and divide by 4. The gauge will move in 5 gallon increments. So once it comes off F you will have somewhere between 15 and just over 19 gallons in the tank. IMHO this is terrible resolution.The colors are easy to change and is a nice feature. The bezel is small so if the hole is a bit oversized or not perfectly round you'll see it for sure.I haven't had a chance to mount it in the tank so I can't report on whether or not the holes match the existing WEMA sending unit.EDIT: The holes match standard sending unit hole patterns. Fit like a charm BUT, you do have to orient the new one the same as the old one!I tested the unit outside the tank (dry) and the gauge needle only moved in 1/4 increments but after installation it appears to sitting at around a 1/8 increment (7/8 I think). Huh. Will report more when I finish re-wiring the hack-job I bought and get to really test it.

I installed this product on my ezgo golf cart and it turned out to be an easy install.

Finally got to the point to install fuel gauge and sender unit after it sit on my shelf for 2 months and it doesn’t work. Instructions were followed and I’ve tried troubleshooting videos but it’ll either show full tank or empty. I have half a tank. Don’t waste money on this one

Worked great on my older Bass Tracker, Took me a moment to figure out the wiring for the gauge but once it was all sorted out it works perfectly

Todo quedó como nuevo

Recommended.

Works great

Works perfectly. Exact fit. Excellent purchase

Muy buena calidad y excelente tiempo de entrega

All details of this add for the fuel sensor were accurate. It came protected with foam and looked brand new. Installation direction of the sensor and washer to the original tank is very important because the spacing between screw holes are not all the same. Check direction of the old sensor before removal.The sensor works great. The only negative thought was the washer is smaller than the metal flange making it hard to line things up when your arm is down in the hole blocking the light and your vision.It comes with new screws.