Redi Shade No Tools Easy Lift Trim-at-Home Cordless Cellular Light Filtering Fabric Shade Natural, 30" W x 64" L, (Fits windows 19"- 30")

I ordered 4 of these and have had them on my windows for a few months now and LOVE them! I had read a review before I purchased them to go ahead and order a double sided mounting tape because the original adhesive isn't strong enough. So I ordered the Gorilla brand off amazon and it has worked SO well. I heated up the double sided tape and the original adhesive to make a good bond before installing to my windows. I didn't have to cut mine at all because they fit inside my windows really well. The last one I installed has only started to come undone 1 time. I thinks its because I was rushing to finish and didn't heat the tape up as well as I did on the other 3. These are a GREAT price and I loved that I didn't have to drill any holes into my windows. I read in other reviews that they sometimes get a little crooked when raising them or pulling them down, this is an easy fix. Just raise them all the way back up and then try again. It corrects itself. I use 2 hands to raise or pull down to prevent this from happening. Highly recommend!

Waited a while to start my review in case there were problems, but so far SOOO good! I put these up fairly quickly, all by myself. Cutting them down was a bit of a challenge, but they do cut with a kitchen knife. I did follow a suggestion from another customer review to use a 3M tape for a more secure install, as my windows do no have a large lip to install them under. I kept the old heavy blind for months, just in case, but these have held up beautifully. Very pleased with the quality, the aesthetic and the price. Finally chucked the old heavy plastic blinds that kept bowing and falling down. Plan to get more of these for the front of my house so everything matches and for better privacy and light-filtering.

Quality is good for the price. Note that this is the CELLULAR version which means the shade design includs cells or pockets, which seem to filter more light while also helping with temperature control and blocking more heat from entering the home. (The same company also sells a PLEATED version which appears to not offer the same function of filtering light/heat.) The pull-down/lift-up function works great, no pins or clips required. If the shade position ever becomes uneven, simply raise the shade back to the up position and then pull back down to "reset" it, as the instructions indicate.Cutting down the shade to fit the width of your window is no problem. As the instructions state, measure your window WIDTH three times (top, middle, and bottom), and use the narrowest measurement when you use the included cutting guide to cut down the shade on each side (left and right, using your width measurement as your cutting point on each side). MEASURE MULTIPLE TIMES to be certain you have the right measurement. Then firmly secure the shade to the floor, apply the plastic cutting guide (included), place the slit over the exact position indicating your window width (for instance, "42 3/4") and then use a short, sharp, smooth blade kitchen knife to saw/rock back and forth until you cut all the way through. Repeat this on the other side of the shade, at the same measurement marker on the ruler. Once you've cut down your shade to the appropriate width, hold it up inside your window frame (top, middle, and bottom) to make sure it's not too wide. (It's going to be easier to cut it down further now than after you've installed it!) Then pop in the bar-ends (included) into the cut ends to finish the base of the shade.Adhesive: THERE IS A GOOD SOLUTION to the many problems others have mentioned in the reviews for this product.. DO NOT WASTE YOUR TIME RISKING TO INSTALL this shade using the pre-installed adhesive tape. Instead, I STRONGLY recommend searching Amazon for a 3M "VHB" 2-sided tape (usually back tape with red backing), preferably 1" width, and at least as long as the length of the shade. This should cost you about $9 or so. Order the tape at the same time as you order the shade, and don't attempt to install the shade until you have the 3M VHB heavy duty 2-sided tape (NOT SQUARES). Trust me on this from experience. Now, assuming you've purchased a roll of high quality (3M VHB heavy duty) 2-sided tape, and you've cut your shade down to side: REMOVE the backing from the adhesive tape that came pre-installed on the shade so the sticky tape is exposed. Now, unroll your 3M VHB 2-sided tape and CAREFULLY extend the tape from one edge of the shade to the other, applying it DIRECTLY onto the factory-adhesive tape, and firmly press along the whole way to make sure it's firmly attached with minimal air bubbles. (To make it even more secure, you can now blow a warm hair dryer directly onto the tape to heat up the adhesive, just for 15 seconds or so, and then press it down again firmly.) IMPORTANT: DO NOT REMOVE THE 3M VHB tape backing yet, and DO NOT install yet. Let the shade sit for 12-24 hours so the adhesive forms a super strong bond. It's better to take your time on this and ensure that it holds than regret it later! After you've let it sit for a considerable amount of time, clean the window frame / area of any dust, dirt, etc. (use alcohol if necessary), especially the area where you'll be attaching this shade, and let it THOROUGHLY dry. Finally, remove the 3M VHB 2-sided tape backing from the entire shade. (Optional: you can now use that same hair dryer technique once again, this time on the exposed adhesive, to warm it up and increase its ability to bond.) Now, very carefully press the shade in EXACTLY the position you measured from. HOLD IT IN PLACE for as long as possible, periodically shifting your hands (left and middle, middle and right, etc) so you're evenly distributing pressure, holding the shade and its adhesive against the surface to form a super-strong bond. Periodically shifting your hands, and pressing as firmly as possible, for as long as 5-10 minutes (or more!) will greatly enhance the bond, and decrease the likelihood that your shade will ever fall down unexpectedly.Good luck!

This shade was easy to install (I followed a reviewer's guide to use 3M adhesive tape in addition to what comes on the shade), and looks nice. However, once the shade was opened, it only retracts part-way up. Nothing in the manufacturer's FAQs or bot's answers addressed that. I had to create a strap to hold the curtain up when we don't want it down.

Uso este tipo de persianas porque tengo gatitos y destruyen otras cortinas o persianas por más que las cuido. Estas también las rompen, pero duran unos 6 meses y se ven bien. Sencillas, desde luego, pero pasan por persianas normales por un buentiempo. Solo espero que las continuen surtiendo en todos los tamaños y no las suban de precio. Más caras no las compraría.

Me encanto!! De todo a todo, desde el sistema de corte, pasando por el sistema de montaje y por supuesto el sistema inalámbrico. Funciona de maravilla! Se adaptó a mi ventana como lo tenia yo planeado y se ve muy bien.

The quality of the product is great. I chose them for my living room based on filtering light rather than light blocking. They work wonderfully for this purpose! Getting them put up was rather tricky. However, after a few false starts, they were easy to install. Within a few days, two out of four shades started losing the grip. To be fair, the adhesion strip was flat but the surface I was trying to attach it to is not. When I pulled them completely off it made a mess of both the painted surface and the adhesion strip. I ended up using sets of command strip velcro hangers (see photo) (four per window shade). This works and will also allow me to take the blinds down without damaging the surface they're attached to. It’s also tricky to get them level when raising them – kind of hit and miss. If anyone has a suggestion about how to get them level, I’d love to hear it. The bottom line for me is I’d recommend these to friends and I’m going to order the black-out version for my bedroom.

Ok

Good value for an affordable blind. The adhesive does hold but you have to find a way to clamp the blind in place at least overnight but the longer the better.