4" Wood Lathe Steel Faceplate, 1”x8TPI Spindle Thread Woodworking Machine Chuck Face Plate

Balanced chuck with many dcrew hole options for fastening blank for turning on older Delta lathe.

This Face plate is made of quality steel and is machined square.Small but still strong enough to hold 18 inch maple bowls.

This is a good value. It is very flexible for many different projects. It has good grip when you compress it longitudinally. If you need to make it grip from the sides, you can easily rig up some screw tension grips using some angle iron, screws, nuts, and the existing holes to secure them to the piece. Weigh the pieces and make sure the rig is balanced before spinning it. Start with low speed, double check that it’s balanced, and then gradually increase the RPM’s until you’re at your working speed.

Used by woodturners and a size appropriate for many bowl blanks.

This is a good face plate fits good made out of steel the price was good I will recommend this face plate to any one that wants quality at a fair price. Didn’t give it a five because the finish could have been a little better. But most folks are not looking at the polished surface.

It’s a solid plate and would do great but not the right size. That was my fault for not measuring first.

Well made; good machining, the only issue I had was that it began to rust after the first use. I live in a very high humidity environment, so it should work well for most woodworkers.

I’m hoping it’s the right size.