Anina 6 Pin 12AWG DC Power Cord Cable, 1M Short Wave Power Supply Cable with 30A Fuse Compatible for Yaesu FT-847 FT-857D FT-897 Kenwood TS-870 Icom IC-740 IC-751 AlincoDX-70 DC-77 CB Mobile Radio

could be longer to get to the battery. Is worth the price and does come with a couple connectors.

It would have nice to have the two wires connected together, had to go the Harbor Freight to buy plastic wire wrap.

Bought this 'shortie' to replace the long connector cord that was on my FT 857D ham radio...the longer cord went into service on my portable installation in my truck. Easy replacement...and the desk looks much less cluttered now...

I absolutely love the quality of this cable, and it's flexibleness going between my astron amplifier and my Kenwood TS570S here in my shack. The cable came pre-strip for easy connectors which were also included, and two great 25 amp fuses as well. This is all plug and play ready between my radio and the power supply. I definitely would order this again if I needed a short jumper radio cable. The value for the money is awesome as well. Look at my photos and you can see the photo in the back of the radio as well as from the front view, though the front doesn't really show the cable as much but you see how close they are side by side. Enjoy your purchase and take pride in knowing that this is a good price and good quality cable.

Found out the fuse holder are junk had to remove them as they were so loose the radio kept shutting down if you bumped them

It's OK but it wouldn't hurt if the wire was of a bit heavier gauge.

Just an FYI, the fuses fell out of the fuse holders. The quality was so poor had a 30 amp load been applied the holder would have melted to to very poor blade contact.

FYI.The tension of the terminals on the fuse holders are inadequate, does not make tight contact.Used a pin extractor, disassembled and had to squeeze the terminals tighter.Fuse now fits tight and can handle the current.