MaxTool 5" TCT Hole Saws 127mm Carbide Tipped Holesaw 2.25" Deep Cut for cutting asphalt brick concrete gypsum limestone tile wood MDF; CT00Y57R500

I normally don’t write reviews but this hole saw worked so well at drilling through 8 x16 cement block I had to do this. Drilling 5in holes for a portable A/C unit for my garage. Need to drill from the outside but no problem takes about 10 minutes with a 1/2 drill and I’ll be done. This was the lowest price saw I could find but it did a great job!!

After 30 min of using the 5" hole saw I was only able to drill thru 1/4" of brick on the side of my house. I ended up buying a diamond hole saw instead - much better choice for going thru brick.

Did the job. Made a hole in the drywall in less then 5 sec. stucco caused visible wear , but i was able to complete what i needed. If you buy it to make holes in the stucco, most likely it is a single hole product.

I used this to droll I-Joists for drain line.I used a laser with the correct slope and used the hole saw to drill through the I-Joist web. Drilling was easy as the web was 1/2" thick and the core ejected fairly easily.

This hole saw works better than some, it does not grab and kick back, works very well.

Works great. Used it to drill holes in cement board. Went through like a hot knife through butter...

Much less pressure required than usual hole saws. Made a quick and clean cut through the wood and stucco without any “grabbing”. So impressed that I may purchase the other sizes Delivery was quick and efficient - came a day earlier than promised.

Purchased this 5 inches hole saw to cut through a 4 inches concrete slab. Took me some time, but mainly because I used a regular drill (which overheated) so I had to cool it not to damage the motor.I used also spay water to make sure the holesaw was not damaged by the heat. quite a process, but for that price, very happy. I got the result I was expecting