FarpidaVCM Muzzler Harness Disable Kit Fit for Honda 3.5L V6 Engine with VCM, for Honda Acura Pilot Accord Ridgeline Odyssey Muzzle 3.5L V6 Engine with VCM

This literally is just a wire extension that just adds a resistor to the line so the car does not enter eco mode. That's all it is and this product does exactly that for a good price point.That being said, unless you actually test to confirm which of the 4 resistors provided works as intended with your vehicle (all cars have different wear/issues even between the same models/trim), it seems silly for people to label this product as faulty given what it is. In fact, you could find tune the product by providing your own resistor if desired.Additionally, if you bought an item like this that is supposed to prevent uneven bleed in your car in the first place, it may also be a good idea to replace or check your spark plugs to make sure they're in good condition (unless your car is new), as uneven wear in your car has ALREADY occurred and adding additional resistance in the sensor loop may cause issues like misfiring or for the car to go into "limp mode" or even turn off. While adjusting the resistor can work, cleaning you coils and replacing your spark plugs would probably be ideal before installation of this product as you would want to "even out" or "reset" your car before using this product.Bottom line, this product works fine, but may require some understanding or additional car maintenance for proper installation and use.

Installing this was a breeze, took maybe 5 minutes. I then took my 2011 Honda Odyssey on a quick drive to get gas with my daughter. Everything was going good until I went to pull out of the gas station. The van stalled and died in the middle of the parking lot on a hill. I restarted the van and drove maybe 15 feet and the van died again. The check engine light came on and I immediately popped the hood and removed this device.After removal, the van drove normally as it did before installation. When I got home I ran the CEL codes and got a "Intake temperature sensor circuit high" code.I cleared the codes and the CEL has not come back on.I had my daughter with me and this could have been alot worse. If we were pulling out into traffic and the van stalled, I don't even want to think of what could have happened.BOTTOM LINE: If you value your family's safety and your own, DO NOT install this device on any vehicle. This was confirmed to fit my van through AMAZON garage.Sent the item back for a refund.

It seems like it has what you need, but I had to watch a video to find the ECM sensor location and look at a listing for a different VCM Disabler to find the instructions on how the resistors are to be used. Includes 4 resistors and says to make sure resistor is connected before installation, but doesn't say which one to connect or how to connect but spends most of the instructions explaining how to remove / install the engine cover and disconnect electrical connectors.

Hopefully it works so far so good on the install.

Cheaply made, car wouldn't start after install, components fell apart, trashed it.