2PCS No Wire 1 XT60 Male to 2 XT-60 Female XT60 Parallel Battery Connectors for RC NiHM Lipo Battery ESC

No problems at all. They fit perfectly with other XT60's and they are sturdy.

Used in my RC4WD bully 2 go the pair of hobby wing fusion motor/ESC 's. No complaints.

Far better to buy then DIY yourself.I used this to split from my 4s 2200 to split between my Castle ESC & MOB Audio amplifier on my rc crawler.

This was used to split the output of my ebike battery. One end went out to the motor controller, and the other went out to a 48 volt to 12 volt converter to run chargers and electronics. I went to unplug my battery and this entire adapter broke apart. I found that it had been held together by just a very small amount of hastily placed solder. It's actually pretty lucky it held up as long as it did.I know this was hastily done because not much solder was used, it did not make a good bond to the terminals, and the terminals were very far out of alignment. The only thing holding this together was the solder, which is brittle. The proper way to do this is to use heavy stranded wire inserted into the hollow terminals, and properly soldered in place. Whoever made this could not be bothered to make this properly and it failed on me. Thankfully I was not out on my upcoming 2 year road trip, or the failure could have stranded me or possibly damaged my battery.If you buy something like this, cut off the heat shrink wrap and inspect it before use. If you have the means to do so, buy the connectors and solder them together yourself. This is what I'll be doing.

I could have made one of these myself, but didn't have the correct materials at hand. In the interest of time I ordered (fast delivery) and put to use quickly. Well built and work perfectly.

Excellent piece. Saw prior reviews complaining about quality control. Checked with multi meter for polarity. Put in my scooter to add second battery. Hit plenty of bumps and pot holes.. Still going strong!!

I used this on my Clodbuster build with dual Hobbywing Quicrun 1080 ESCs. This parallel connector is more efficient than anything I could solder up with cable and connectors. I have run this pretty hard and has held up great.

The XT60 adapters arrived as expected. They are delivered as pictured. They are not parallel connectors as described but can be used to split a single battery. This is what I expected. Tested continuity to make sure they were connected correctly under the heat shrink.Not sure about durability but appeared to be connected well.Update 5/28/2021Well i was wrong. Worked maybe 3 times with VERY gental use and the solder points broke. There is no wire between connectors... Shockingly poor quality. Should be an embarassment to anyone that would sell this.

Broke on first attempt to use. These are soldered edge to edge of the pins on the XT60 plugs that results in a tiny contact area and a very weak joint. If you need a Y (wye) adapter or splitter, buy one with thick gauge wires between the plugs.

Do not buy! The connector snapped first time I tried to use it. Very poor quality.

Was sent the opposite of what was needed...Someone was gender confused...