VIAIR350C - Small Industrial Air Compressor for ‎Drilling, Air Brushing, Spraying, Nailing | 12V Continuous Duty Cycle Compressor, 150 PSI (Silver)

This was bought to replace a third failed Hadley 850D for the air horns on my motorhome. There is no comparison. The Hadley had an air filter about 5/8" diameter, and the crankcase end cap constantly fell off. This one has an effective, replaceable air filter, robust crankcase design, and in addition, a built-in check valve.The Hadley had a 23% duty cycle; the 350C is 100%. And it pumps up the system in 1/4 the time, and holds the pressure for days thanks to the check valve.Since it has 100% duty cycle and runs cooler than its predecessor, I'll soon put a hose disconnect so I can pump up the tires.

This is the same compressor I had in my old truck. I bought a train horn kit and the compressor that came with the kit was only a 10% duty cycle so I purchase this one because I was familiar with it and it has a 100% duty cycle @ 100 psi. I mounted it under my truck tucked up tight away from any possible water getting on it. I can fill tires or a raft and floaties or my overload air springs. I installed the 2.5 gallon air tank and have a fitting so i can plug in a hose easily. i love this compressor

I had 2 of these compressors installed on my Silverado to fill a 10 gallon air tank. They worked flawlessly then, and still work without any problems on my Jeep. After a few years of running these on my bagged truck, I now run one on my Jeep for the trail. I chose the 350C over the 450C because of the size. I had two mounted in the engine compartment of the Silverado. Now one is mounted in the cargo area of my Jeep. It will fill a 33" tire from 5psi to 35psi in about 2 minutes. Amperage draw is not that much, but put a relay to save your switch.

Exact replacement for compressor on kinze 3500 with pneumatic down pressure.

was a direct replacement for our fire truck. works great easy install will buy again if needed

Light? Didn't want a light, just a compressor to run an air slave cylinder for an exhaust brake. Works great. Came with two filters, air suction hose and fastners.

Ok so I will start off stating I don't usually do these but on this occasion I will make the exception. This is a great compressor for what it is supposed to do, however I bought this for a completely different reason. I bought this to replace the one that went bad on my Case IH 1235 stacker bar planter. For the other farmers out there yes it is the same one case parts is asking a hell of a lot more for, only thing you will need to swap out your filter assembly. I would take a note from this kit and move the filter to the cab where there is less dust. This is an excellent little continuous duty compressor filling 12 down force bags and a tank keeping around 100 psi. So if you are wondering if it would be good for you vehicle just remember they put it on heavy equipment.

Replaced a 40 year old GMC suspension compressor that was not working correctly. Seems to improve the drivability of the vehicle.

Much quieter than the 100 cfm Klienn compressor that I burnt up...

This was my 2nd purchase

Excellent compressor.

Quick little compressor fill tire blink of an eye!!

i liked the product. 100% duty cycle.