Full description not available
L**S
Defective items
Installed cps for bank 1 after getting p0340 code. After install started getting code p0011 for advanced timing. Didn't have that code before. Read on nissan forums that this code could be for bad cps also and decided to install cps for bank 2. Started to receive code p0345 after bank two install. Figured it must be bad sensors, removed bank 2 and put original back and code p0345 went away. Decided to follow advice from nissan forum and buy cps from Delphi brand. Ordered it from amazon also, replaced it and truck runs great and no more codes.
S**E
These are straight up garbage
I had a check engine light with a code for cam position sensor. I went ahead and bought the set of two new ones, installed and reset the check engine light. Within two days, check engine was back on, this time both sensors failed. Ended up putting the one good used one back in, along with one new OEM part and troubles are over. But these two ended up in the garbage can. A complete waste of time and money, only good thing, they weren't too expensive. But they're just s&*$#@)t.
A**I
Hoping it would work
I figured for this much money it was worth a try. I installed this new bank 2 sensor for code p3405 and the sensor did not fix the code throw. I bought a set of Nissan OEM made in Japan Cam sensors, $178.00. Installed the bank 2 and instant repair so far. I should have done that from the start. Also the new OEM parts are obvious upgrades with metal sensor areas as opposed to the old black plastic looking config.
R**T
They are worthless junk
If I could give zero or negative stars I would. DO NOT BUY THESE PIECES OF JUNK! They cost me money in towing and time from work! They wreaked havoc on my engine!
T**E
Go oem
Both sensors quit after 10 miles. Luckily I was near home so I didn't have to drive the truck far. 05 nissan frontier 4.0. Scanned the check engine light and both sensors went bad and showed bank1 and bank2 over advanced. I know the timing is good and bank2 sensor still work and was OEM but decide to go ahead and replace it while I was doing bank2 sensor and had the intakemanifold off.
J**N
Very cheap
Out of the two senors one worked and the other didn't work at all. Then I started getting new alarm codes so I put the stock ones back in and the new alarm codes went away. Then I went to O'Reilly auto parts and bought two from them with life time warranty and they worked good. I would never buy these sensors again.
A**R
Absolute garbage.
Garbage sensors. Increased crank time significantly over old failing sensors. Failed completely and threw engine codes after 3 hours. For Nissan VQ35DE Quest.
A**R
JUNK
These are junk, one even came DOA, circuit was open. The other causes my engine to skip and sputter. Easy return at least.
Trustpilot
4 days ago
2 days ago
