FYSETC 5PCS FEP Film Release Films 200 x 140 x 0.15mm, Photon-Mono Fep Replacement High Transmittance for ElegooMars Mars2 Pro Mars3 AnycubicPhoton Mono4K LD-002R Resin 3D Printer Accessories

I bought these after seeing the prices of the FEP film made by Anycubic for the Photon and wasn't expecting to be quite as good at this lower price but so far I'm pleasantly surprised. They do seem a but thinner than the film by Anycubic but I've done quite a few prints with this film installed and so far I have no real complaints, it preforms just as well as the Anycubic film

As many have said, this is thinner than Elegoo brand FEP film, but since it was so much cheaper at the time I decided to give it a try. So far it has installed well and every print job has turned out perfect.The major con is that it doesn't have ANY protective film, just the five FEP sheets packaged together in a protective envelope. This means that by the time you get them separated they already have a few minor scratches, but nothing that you don't have after your first print from handling and typical release bruising.The pro is of course the lower price, due to the cons of thinness and lack of protection I will only continue to buy them if they remain significantly cheaper.If I end up having poor results or the sheets only last a couple of prints I will update this review, but so far, so good!

So I was pretty hesitant to getting these, since they were so inexpensive compared the the MFG brand. The only thing is be forewarned that they are much larger than the base. You will need to take an razor blade and cut to fit. It takes no time to do but be careful, I've probably have done 4 small prints and 3 big prints on them and it still is working. I would recommend these but be prepared when they are oversized and don't freak out.

I have used up an entire set of these on my Elegoo Mars and Mars 2 Pro. Now I am back to normal Elegoo FEP and I miss these...Due to the thinness of these they CAN and will break if you dont clean the build plate and they are not super long lasting. Maybe a hundred hours of printing to two hundred per sheet.The benefit these give is just like nFEP. The thinness means the light shines through stronger and gives FAR better adhesive prints than standard FEP (at least the elegoo version). They make printing easier to do and with less chances for failure BUT you have to treat it with kid gloves.

like a moron, I poked my original film and needed new film for my Mars vat and this worked great as a replacement, had to trim a little but stretches and fits just fine.

My printer company sent extra FEP with the machine ... rolled up and shoved into an envelope.Bought this FEP and it's perfection. Never folded or rolled, kept in static-free envelope and is crisp.Just changed this the other day and it was easy to work with. I have the jgaurora G3 printer and wasn't sure about size, these are bigger than average. Installed it, then cut off the excess with an xacto knife. Good stuff, get some.

Great product, pretty easy install. The elegoo mars comes with all the tools already it was just a matter of following the directions. Highly recommend and will buy more if needed.

I went through all five in one month. After 2-3 prints these sprung leaks and were damaged. They just didn't last for me at all.