Eastfly Car Door LED Logo Upgraded Projection for Nissan Projector Ghost Shadow for Altima AMADAR TITAN Pathfinder etc, Entry Welcome Lamp Logo Light, LED Courtesy Step Lights Ground Lamp

Works great, gonna order for my back doors as well.

These are clearer and brighter than the last set I had. Plus the housing for the projector is more secure than the first set. You wouldn't have to worry about it coming out of place.

The media could not be loaded.  This logo light looks pretty good gave it 4 stars because it does NOT fit my 2019 pathfinder but it did fit my 2006 Altima

These lights look great on my 2017 Altima. They were very easy to install. I didn’t have door lights on the front doors but the cutout for them were there and covered. I just popped the covers out with a small screwdriver and the wire was attached to the cover. I just plugged it into the logo light and popped them back it. It was that easy and looks great. My back doors didn’t have them.

The media could not be loaded.  Replaced the first order due to a short in the connection. It's not as snug as the original lights that were replaced but I've had no issues once they were installed. Love them and would purchase again.

Easily installed using factory wire harness. Literally pop out (watch a YouTube video for your car), detach wire harness to remove existing light, attach product, push in new light. The Nissan image on the ground is bright and eye catching.

These work great for my 2017 Nissan Maxima. They do come in two's. And the bulbs also specify left and right so theres indeed a bulb for the passenger side door as well.The only dislike i have about these are the orientation of the logo. I wish I could rotate the logo so its straight along with the door. It doesn't bother me enough to give it this review anything less of a 5 star, but we will see how well these perform.

For my 2012 Nissan Armada they work great. The Nissan logo is clear and bright and it looks really cool.They are a direct fit with a little bit of trimming of the tab in the existing light cutout in the door panel. So I had to trim, with a sharp knife, a little 1/16" x 3/16" notch where the little circuit board resides once it's installed. It's really not a big deal at all because the light cover hides it once its installed.