Uxcell a11032500ux0133 KSD9700 NC 45C Bimetal Thermostat Temperature Switch (Pack of 2)

This is exactly what i needed for an external power supply I am building. Functions as it should have when tested. will do business in the future!

Kind of useless... it activates the pump every few seconds.I wanted to use it for a temperature trigger in the hot water system loop.Water is at about 50 C to 52 C, so 45 C was great setting. It activates just fine (although the temperature is off by about 3 degrees - it kicks in at 48 C to 49 C), but it resets at 46 C to 47 C.Nowhere close to reset of 30 as specs says. I thought, let it be at 35, 38, well, even 40. But one or two degrees below the trigger? Oh well, poor design.Oh, I tested both of them. They react same way.

I purchased these Normally Closed switches for a project. Unfortunately I actually needed Normally opened switches. However, I did test them and they both opened and closed correctly.

Used this thermal protector on the windings of a VitaMix VM0100A Blender. Easy to attach to windings with cable ties and wire into current flow with terminal lugs on stripped end of lead wires. Unless you need large quantities, the price is very good. Shipping was free, but took about 10 days or so.

Used in my cat's Sleepy Pod heating pad- saved over $50 since I didn't have to replace the whole pad.

At first hey work as intended, but none of them made it past 3 months though, they will just stay closed

Leads are long enough.

good equipment