Remove your stickers/graphics Once your stickers have arrived, remove them from the packaging. Lay the graphic flat and add weight to each end to flatten out the image, a flat graphic will be much easier to apply. Remove excess material If necessary cut away any excess material using sharp scissors to trim around the graphic. Add Pressure Just before you apply your graphic, smooth the graphic down with moderate pressure from the centre outwards, using a plastic squeegee or credit card, to allow the transfer tape to take a good firm hold of the graphic. Peel Away Silicone Paper Place the graphic upside down and slowly peel away the rear silicone paper at a sharp angle ensuring that the graphic remains on the application tape. If the graphic does not remain on the application tape, put the silicone paper back on and smooth down application tape again. Apply the Graphic Once all the silicone paper has been removed, position the graphic in the desired location very gently, check it is in the correct position and level, then apply the graphic to the surface pushing from the centre outwards with a plastic squeegee or credit card. Leave for 10 minutes then squeegee over the graphic again. Let the Graphic Set Once your graphic has been applied to your surface, wait at least 10 minutes and then remove the application tape by peeling a corner back at 180 degrees of itself, and slowly peel the application tape off the face. Remove any bubbles by pricking at the edge with a sharp knife or a pin and smooth them down, make sure all parts of the graphic have been pressed down.
Trustpilot
5 days ago
3 weeks ago
