Bathroom Sink Drain,Drain Stopper Bathroom Sink with Overflow,Pop Up Drain Assembly with Detachable Strainer Basket,Built-in Anti-Clogging Strainer,Stainless Steel Mattle Black

Very happy with this upgrade. So easy to clean and install. Looks great too. Purchased a pack if 2 for both bathrooms. No issues for the install. Just remember to align the overflow if you get that model.

No tools needed if you can free the last fittings on the old one for removal. Drain plug is a sturdy pop-up that works well.

This product was easy to install and looks very nice.

So I purchased two of these and installed them both today. I think the folks who have had trouble with leaks may have encountered an installation issue. You must pay attention to the location of the washers. There are no instructions with the product so you have to look at the videos on Amazon. The first one took a bit longer than the second but that was to be expected. Disassembly of the old system was really pretty easy but don't forget to put a pail underneath the trap or you will have a few ounces of water on the bottom of the cabinet which will be most annoying. The order of the washers: One of the larger washers has to go on the upper sink side and it goes in "cone shape" down.. The washers on mine were put on the device out of order. The flat washer goes on 2nd, on the underside of the sink, followed by the other larger washer and the "cone shaped" part of the second washer goes up. Screw on the gold metal part and hand tighten. It really is a thin piece so I can see how it might break if over tightened. Next slide the screw top that attaches to the trap followed by the washer on to the drainpipe and then insert the drain pipe into the front side of the trap. At this point you need to adjust the trap so that it fits on the drainpipe and the other side of the trap on the exit pipe. Tighten each of those a bit so you know that everything will screw together correctly. Then tighten the gold piece on the drain pipe. You really have to tighten it a lot to make sure you collapse the washer on the top side of the sink. It seems to take more tightening that one might expect but if you don't do it correctly, water will puddle in the sink because of the way it sits. It's possible that this is also where leaks can develop. Don't overtighten as you could break the gold piece at which point you will be out of business. Tighten enough to assure a good seal, but don't overdo it. Then tighten the the screw caps on both sides of the trap. Same rule. Tighten securely but don't over do it. Run the water and check for leaks. At this point everything should be good.One thing you need to know which is not clear from the pictures and I'm sure it will annoy some people. When you put the top piece in the drain pipe, as you know, you push it down to close the drain and do the same to release it. Mine held water without any issues. However, when that piece is not pushed down to allow the sink to fill, it sits a full 1/2 inch about the drain hole. It is also quite large and looks a bit strange in comparison to the one you just removed. Photo 1 shows the drain closed and photo shows it open. If you can't live with that, you may want to try a different product.Overall, the product is as described and works well. Installation is not difficult but you need to do it correctly. Finally, you have determine if you can live with the top sitting so high. It does not interfere with the water flow or cause any splashing. I'm really ok with it considering the relatively low cost and less than difficult installation process.I hope this is helpful.

They are durable and get the job done.

Works as described. Changed both sink drains out in less than 10 minutes. Easy and simple.

I had a new vanity installed 2 years ago, a plumber was doing some other work at my home so he hooked up the drain. It leaked from day one, so I put a pan under the elbow to keep from damaging the vanity. Months later I had another plumber look at the drain and he replaced everything, it still leaked.I saw this drain on Amazon and decided to give it a try myself. The hardest part was removing the old drain from the sink. I followed the included directions...No More Leaks!!

DO NOT BUY THIS!!!!!I only had this item for 2 weeks and had to remove it because of the rust. It also was cracked from the inside where the water sits. I live alone and work 12hrs a day so this sink does not get a lot of use.I'm sure there is further damage from the amount of rust and build up in just 2 WEEKS!!!

Fácil de instalar, llevo usándolo un pocoas de tres meses