Dracaena 6 Pack G1/4" Thread to 3/8" ID, 1/2" OD Compression Fitting for Soft Tubing, Soft Tube Connectors for Computer Water Cooling System, Silver

Have about 12 of these in my water cooled system and not a single drop!

The media could not be loaded. By the time you buy all the fittings you need to finish a build you can easily spend several hundred on fittings alone. With some other brands fittings costing $30+ EACH!!! (my system has 18 total fittings) I couldn't recommend any other brand. Bought all dracaena fittings. No leaks, consistent and decent finish. 1/3 the price (or less) of EK, alphacool, etc. Same gpu/cpu temps. Just $300 cheaper to build my system.

I bought these for a custom water cooled PC project. I was using hard line tubing but when flushing and filling, these and some flexible hosing saved a bunch of headache. They're machined well, deburred well and fitment is dead on. Best part is the price being lower than the name brands but just as good.

They were easy to install and no leaks

Picked these fittings for the price. Seal perfectly with my soft tubing and threaded into my Corsair pump/Res and Corsair Radiators with no issues at all. Sealed perfectly.

I ordered the silver/nickel ones, which dont seem to have the chipping-plating issue people described with the white and black ones.That said, the nipple for the soft tubing seems to be about 1mm too wide. I had to apply at least 3 or 4 times the normal amount of force to fit standard EKWB tubing (correct ID/OD size) compared to a fitting from EK or Corsair. This significantly impacts how I have to plan the physical assembly for my build, as I wont be able to apply so much force to the fitting after its threaded into my block/res/pump/etc......Also, once the tube is finally on, there isn't enough room for the nut to screw on over the tube. The nipple neck part is just too thick by about 1mm. I absolutely destroyed the ends of my fingers trying to mount/screw a scrap piece of tubing to test the fit.

Used these for watercooling my PC with soft tubing, before jumping into the time consuming hard tubing. These work very well with 0 issues or leaks. I did of course use white plumbers tape on every threaded area to insure it doesn't.

As stated, these fittings are not compression fittings. The collar does not come in contact with the tubing while installed on the fitting barb. The collars only function in this situation is for aesthetics. Other than that the fitting is nice. Will be returning and putting a 2 star since the main advertising function is non existent.

When doing my water loop I was going to hard line it after using this fitting with soft tube I was amazing on the look

Compre 2 paquetitos para mi loop y hasta ahora todo bien, sin cosas raras, filtraciones o nada indeseable. Por lo que costo creo que tiene excelente relación valor-precio. Hasta ahora no se me han despintado ninguno como lo dicen en otro comentario. Ya veremos que pasa mas adelante.

The compression fittings feel high-quality and durable with their brass construction and black chrome finish. They provide a leakproof seal with an embedded O-ring. However, tightening them on EK's ZMT Tubing was challenging (I blame EK's tolerances, not these fittings). The minimal packaging (just a plastic bag) could be improved. Despite these issues, I would buy them again.

Does the job and no leaks, perfect.

The paint in most of the fittings is chipped and the paint debris is stuck to the o-rings. I think it's because they all come in the same bag without any protection. I'm sending these back.