EZ Lip – The Original Universal Fit 1-Inch Lip Spoiler for Bumper

I was skeptical at first. Not sure of the durability or if the double sided tape would actually last. Worth every penny!HIGHLY RECOMMEND! Make sure you thoroughly clean the surface before attachment. I used ACETONE after I cleaned with soap and water. After you clean the surface thoroughly use an Adhesion Promoter. ( purchase on Amazon ). Apply the adhesion promoter approximately every 8-10 inches then press on the EZ Lip 8-10 inches before the adhesion dries. Repeat until your done. This will absolutely give the EZ LIP a more permanent fitment on for car. Once it dries and bonds with the EZ LIP, it will take an army to pull it off...LolI wanted mine to be more permanent so in addition to the adhesion promotor I also used self tapping screws once the EZ LIP was attached. Absolutely flawless!!!!!!!!!!!I have received soooooooo many compliments on both of my vehicles that I've used EZ LIP on. I bought both RED and YELLOW.

Easy install. looks good. Make sure to clean the surface really good before installing. I used a heat gun on the adhesive for a stronger bond. Material is a soft rubber so it makes it way easier to work with.

I recently decided to give the EZ Lip – The Original Universal Fit 1-Inch Lip Spoiler a shot for my car, hoping it would enhance its appearance. However, I was disappointed by the quality of the material used in this product. The lip spoiler felt flimsy and lacked the sturdiness I was expecting. After my initial disappointment, I opted to try a different brand that was significantly cheaper. To my surprise, the alternative product boasted a much higher quality, with a more durable and robust construction that clearly outperformed the EZ Lip. Given my experience, I cannot recommend the EZ Lip spoiler due to its subpar quality and suggest looking elsewhere for a more reliable option.

Very strong material it was tested on really bad roads. All happened was it scope out a lot of mud. It was however screwed down just to be safe.

EDIT: Updated review. I purchased the EZ lip in January 2020 and this last weekend, it finally ripped (August 2021). My car is lowered and I try to drive carefully on roads with dips/bumps. There are some roads where there just isn't much you can do. On these roads, I've scraped the lip and for the most part, the lip had held up well. There were a few scuffs on it, but nothing that was easy to see so I wasn't worried about it. However, this weekend I was driving and scraped it (didn't think it was very hard) and it ripped the lip. Moral of the story, it's a good lip... it's cheap and looks good. I'm not out a ton of $$ like I would have been if I purchased a "real" lip for this car. But after this, I'm not sure if I'm going to replace it or not.I've been wanting a lip for the front end of my Fiesta ST but didn't want to spend $$$ on something that was, 1. only for looks, and 2. probably going to meet a few speed bumps eventually.The EZ lip was SUPER easy to install. I left the tape out in the sun on a hot day to get it nice and warm. I cleaned the bottom of my bumper and honestly didn't even do a great job (no alcohol or other adhesive prep). I lined it up before peeling the tape off to get an idea of how I would handle the different curves in the bumper and when I was happy, I started at the passenger side wheel and then, working about a foot at a time, stuck the lip to the bottom of the bumper. I pressed it on in sections, pretty lightly just in case I needed to peel it off and move it. When it was all the way done, I cut the end and firmly pressed the lip onto the bumper. All said and done, took me all of 4 minutes to install, minus the cleaning time.The lip itself is soft. It's made of what feels almost like a foam. I guess I was expecting it to be more rubber-y based on how it looks, but it seems durable enough. It's easy to tear it if you try to rip it, but I don't expect that I'll have any problems on the car.As far as the adhesive, after letting it set for a few hours, I pulled on it... HARD. The bumper moves but the lip is solid. Also, because the lip is made of soft material, I expect that it will actually resist any scrapes with speed bumps pretty easily.For the price, I highly recommend this lip if you're looking for a bit of style. Really adds a lot to the look of the front end for a pretty low price.

Bought this EZLip for my 240sx, installation was pretty straight forward and very easy. Only downside is that the adhesive did not hold after the first wash. It began to sag & come of. Had to use some glue to stick it back on. So far so good

I'm putting 5 stars so people can see it first,I have bought easy lip in the past for my GTS Lancer and it looks great made it look lower and everything... But when I went to home depo one day I saw pretty much the exact same thing for more than half the price... GARAGE DOOR BOTTOM RUBBER! yes I'm serious... I was so pissed that I would have bought that for 9 bucks and it's rubber and not this cheap easy to rip stuff and this stuff costs 30 bucks! No way, now I have an integra and I bought the garage door bottom rubber and yes it's a bit more work but you're saving 20 dollars, so in my opinion it's worth it! This is what it looks like the the garage stuff, do you see a difference? Because I don't, and yes I had to make holes in the lip it has but I only needed to make 4 and it's on the bottoms no one would ever notice. But it's up to you guys! Just thought to give my 2 cents about it.EZ Lip is a very nice solution for ground effects for pretty much any car.. It is very simple to install. the double sided tape is fantastic and pretty much never unsticks.. make sure the bottom of your front end is clean, I use rubbing alcohol afterwards to make sure there is no nasty on the plastic and bam just roll it out and stick it on. its that simple. I used this on my 2008 Honda Accord Sedan and it came out just gorgeous.. it have the car a really nice sport look .. its flexible so, if you scrape a curb or parking space it wont hurt it. I attached a photo of the finished product on my car .. you can see the difference with the lower ez lip