DiabloBi-Metal Reciprocating Saw Blades for Nail-Embedded Wood - Variable Tooth Design - 9" Length, 4/6 TPI, 5-Pack - DS0912BW5

used it to cut nails removing a fence, went through the nails and was good for cutting tree branches, I cut 130 fence nails and several tree branches and it barley wore the blade, I would have used two of the cheap ones, I'm going to order another set....buy they are well worth the money

Ive bought these a few times and theyve been great.Use them for almost everything, from cutting smaller branches/ stumps to light metal.Just know paint will rub off first use so might stain whatever youre cutting. For the price, great value.

Quality and durability that you expect.

Bought this pak as I needed a shorter blade. Failed to notice the number of teeth. I needed a finer cut as well as being shorter.The reason for 4 stars is because the first blade became dull after only 15 cuts, cutting corners to 45 degrees with 4 18 gauge brads in each corner. This was only 1 x 2 boards.I'll buy again, but I'll check the number of teeth!

I had tried using "metal" 6in blades to cut apart pallets. These worked so much better as the length of the blade made cutting the middle boards easier and the metal/wood combo cutting teeth made starting the cuts much easier. With the metal only blades I had to pry the boards a little loose to fit the blade between. With these I just started cutting. I used one blade to cut apart 4 pallets that all had many extra nails throughout then just typical 2 or 3 nails per. I then used the same blade to cut through wood fence that had metal brackets on metal poles. These blades cut both the wood with ease and the brackets. Even cut a 1/4 in U bolt.

Use with a sawsaw provides a quick,quiet and effective method to clean up brush and trees up to 7" diameter. Works great, safer than a chain saw cutting up tree limbs.

I own 6 saws,I use Freud Blades on each and everyone- I have been building "Heirloom Quality" custom woodwork for 30+ years, my reciprocating saw is used mostly for cutting small limbs, but when I go to one of my 100 year old barns to "reclaim" the old high character lumber for "Barn-wood furniture" I have found this blade is the ticket for removing the very brittle wood, they last a long time, cut very quickly and don't wander like cheaper brands- you will never go wrong with Freud Blades- Thanks Amazon for supplying such a high quality blade, for the ability to shop from the backwoods( I'm 75 miles from any store that carries any reciprocating saw blades ) and to all the folks who take the time to review the products- and Thanks Freud, for the very best in blades and router bits

Once the heat up and blue a little bit they don’t work that great.

Lasts longer than dewalt blades used where can’t use skill saw

Had to widen frames for windows and trim studs with screws and nails in them. These blades work well you don't need a lot of pressure on the saw to cut the material.Works well and doesn't splinter too much.

Well worth the money

Best what I used until now. I'm doing windows and doors installation.

good blades