Brilliance Laser Inks 50 Grams Black Metal Marking Powder with Foam Brush | Permanent Durable High Contrast Laser Engraving Accessories for Fiber, YAG, and CO2 Laser Engraver BLI101MBPWD50

Likes: easy to mix, and works well with my laser engraver. I should have gotten the pre-mixed spray. At first I tried using it as shown on their website, brushing it on. I wasn't sure how thick of a layer should be used. I gave gotten better results by mixing it in a spray bottle, and spraying it on. So, just buying a spray can would have been easier. I am curious just how dangerous this stuff is - the first few times, I was careful to wear rubber gloves when using it. After forgetting to put on gloves and not noticing any ill effects, I have been using it without protective equipment. I only use it occasionally, for my laser engraving hobby, so maybe the precautions are more relevant if you're using it all day every day in an industrial setting?

Easy to apply and works very well on metal engraving. A little goes a long way. Arrived on time and in excellent condition. Packaged nicely.

This was just a piece of ceramic tile I had in my scrap pile. This is about a half dollar size and took about an hour. Mind you I only have a 10w laser so I have to go very slow with it.I laser engraved this with the powder mix just as follows. Did a perfect job on my first attempt!Very much recommend!!!

I have a very nice xTool S1 40w Diode Laser. After many tests on stainless steel I could not get a good quality result. Test grids with a variety of speeds and percentages of power and resolutions (lines p/cm) either provided a mark that could be rubbed of or a mark where the product was partially burned/charred. Their website provide only a few sentences of instruction... VERY DISAPPOINTING. Near as I can tell this product might work with CO2 lasers but the company states that this product also works with Diode Lasers.

I found this this powder concentrate as an inexpensive way to get great quality marks on metals and stainless steel specially when you have a mass production of large surface areas, Use an Air spray but brush works as good.Got a great quality mark, as instructed. I put a thin layer with No see Through Rule and it works like a champ.

This product exceeded my expectations. I normally dont write a review but was compelled to do so because of the value this product provides. Similar items on Amazon list for more $$ but this does a great job for less. Very satisfied with the results and practical use of the Black Laser Ink, it does exactly what it says it will do! Will be buying again! Thank you for the wonderful value!

, tomar en cuenta que debes conseguir el Alcohol cuando te llegue para prepara la mezcla.

Is flakey. Gets everywhere. I hate this product. Their spray is better