SHNITPWR 24V 3A DC Power Supply Adapter AC 100V~240V to DC 24 Volt 3 Amp 72W Converter Transformer 5.5x2.5mm Plug for 5050 3528 LED Strip Light 3D Printer LED Driver CCTV Security System LCD Monitor

Works great and easy to install

I bought this for my broken power supply in my TS100 soldering iron. It's light weight and works perfectly. Honestly like it better than the original because the ac cord fits tighter into the brick than on the original.

Whooo wee! Thank god for this, plugged it into my light and it was so bright! The only thing is that when it's on for a long period, the brick gets pretty warm. Some days when I'm tattooing I'm wondering if it's going to explode. If it ever does I'll let y'all know.

Works well for powering LEDs and Fans for 3D printer enclosure. power brick is a bit warmer than what I expected, pulling about 50% current load of the maximum supported, but no issues so far.

The power supply is better than the original that came with my whole-house speaker system distribution panel. The accurate item description enabled me to make a smart selection to get the exact specifications verified quickly. The item arrived days ahead of the original estimated date. I am completely satisfied with the seller and the item.

Upon recieving this power supply, I first noticed that there is a connector included for tensioning wires without a solder or crimp connection. I did not end up using this, but it would be very nice for other projects.The voltage tested out perfect, and the current was enough to run a 24vdc light at 3 amps. I have not noticed the power supply getting warm or hot from power on to the light or on standby.The only slight negative i would have is that the main power connection from 120v likes to wiggle free a little bit too easily for my taste, but that's not nearly enough to take a star off since it's easily fixed.I'll definitely be buying more for my next DC light projects.

When plugging this in with the included power cord, nothing happened. No light on the adapter. I fiddled with it and found an identical power cord around the house with a sufficient amp rating, and the light came on.I plugged in my 24 volt 50 watt LED strip and they lit up fine at full power. When dimming the LED, the adapter makes a high pitched noise. This adapter was recommended for the light I purchased and fits the specifications.So it's going back. I may have lived with using my own power cord instead of the defective cheap cord included, but I can't live with this noise. Looking for a better option.

Exactly what I needed. Am using it to power a thermostat for a DIY heating system setup. The little connector that came with it has label showing pos and neg sides with screw-in wire brackets. I was expecting to have to cut the wire and use a multimeter to figure it out (I still did) but I didnt need to. If the brackets were just a liiiiiitle bit bigger, enough to fit a 12ga wire that would have prevented me from having to stretch it with a screwdriver. Also the screw harness will strip, its all soft plastic.

It's only a little Shnit adapter but it provides big Shnit power.

Great product works like a charm

good stuff, good value, would buy again

The cable clamps are miserable to use...typical Chinese quality...I have it all sorted out but a 20 minute job turned into 90 minutes.

Arrived defective. Purchased as a power supply for a motor and this simply does not produce any voltage. Tried a few cables too.