Musical Accessories Wiring Harness Prewired with A500k B500k Pots for Stratocaster Strat Guitar

Makes my guitar better and that's very good

Easy to install, minimum soldering

First no sound then the volume pot broke and I started getting sound. Feels like the knob is about to fall off. Selector switch seems ok.

I love the fact that there are companies out here that make this pre-assembled wiring harnesses. I needed the 500K pots so I could install humbucker pickups in my Strat guitar kit build. The installation was easy. The only complaint I have is that with the volume pot there is little to no adjustment for the volume. It is either on or off. Turning the control down gradually results in no volume decrease until you get all the way down and the signal cuts off. Since I do not normally use the volume control this is not a big deal to me. But it certainly might be for you if you use your volume to clean the signal up to get a non overdriven sound.

It made the wiring process so much easier. But the solder joints were weak and the length of the wire outside of the sleeve was too short. You might need to strip the wires a bit more to solder them back on, if they come off. Besides that, they are Great.

Got what I paid for. They do sound decent for a $5 set of pots.

I broke a potentiometer while assembling my new build. I got the whole harness delivered the same day! It was cost effective to get the whole harness rather than run out to one of the music stores and hope that they have a match. (Most music stores don’t have much stock)Same day delivery is the bomb!

the pots were ok but the 5 way switch is so noisy I'll be replacing it with a aftermarket fender part which would cost as much as this whole rig...so it's a crapshoot...