MENSI Gas Grill Stove Ignition Electrode Spark Plug 36" with High Temperature Resistance Leads DIY Igniter Sparker Pack of 2

I needed to replace the igniters on my grill after I replaced the burner tubes. The tubes gas holes were further from the edge than the original parts so I needed more reach. These worked perfectly. I also liked the fact that they are held in place with nuts as all I needed was a hole for supporting the end. Between the heat and rust, there was no way a screw mount was going to work. The wire end also had a flat connector that fit perfectly on my control.

After a meltdown due to old burners I rebuilt the Kenmore grill with new burners and had to replace damaged wires on the igniters. Since the wires are integrated into the igniter I needed new assemblies. Other suppliers on the internet wanted serious $$$ for 'OEM' replacements so I thought for the price why not try these? They were easy to install, trim to size and adjust - no problem. The only issue was these are M10 threaded and the old ones are 11mm (or English equivalent) but they fit and work using leftover washers from the the old igniters. Grill time!

i used this replace the dead igniters on a charbroil grill. installing them was quite a challenge as the insulator ceramic is quite short and the metal tips are quite long. a lot of bending was required to get them positioned correctly on the burner tubes. the metal tips are durable though. one one of them i had to bend it almost like a hairpin turn.

Loved the length of the lead wire which allowed me to shorten to perfect length and bend into position.

This worked great for my propane heater. It was easy to install and adapt to fit particular application.

Used these igniters on our US RANGE commercial two burner stock pot stove.Worked out great thanks AMAZON! Easy to install and you can cut/bend the tips to fit your project.

Just don’t work, not worth the money

Work great

Remplacer ancien cable de bruleur de BBQ

Je voudrais quelle dure plus longtemps que l’original

Samsung Canada and Reliable Parts wanted $110 for Samsung igniter DG96-00329A. That part is for the high output burner that takes a screw in electrode, not clip in. Usually right front. This screwed right in and it was easy to bend and shorten the electrode. Used the washers to screw it in then removed them so the burner cup could sit right down. Works perfect and saved $95.

Easy installation, threaded body makes it easy to secure the electrode in place. Needlenose pliers made easy work of the bends. High quality braided cable with solid crimped & waterproof connection.

Received these today. On both of the units the glue that secures the ceramic piece into the threaded metal section broke loose during the installation. This is a special glue that can take heat so it cant be repaired with standard glues. I have installed a lot of these so its not the installer in this case. Real PITA since the BBQ is now in pieces.