225mm FPV Racing Drone Frame Carbon Fiber 5 inch Quadcopter Freestyle Frame Kit with Lipo Battery Strap

UPDATE: This frame is durable and handles crashes pretty well. The carbon weave is in the correct direction for the arms and they are pretty stiff and strong. I've been flying and crashing this frame for several months now and have not broken an arm yet. I like it. I haven't crashed it much so I don't know how well it holds up to that. Probably fairly well because it's thick, but if you hit trees at 80mph it's probably going to break. It's good quality, nicely made, but the screws are cheap. If you can replace the screws with good ones it would be a fantastic frame, but they're keeping the price down by using really soft and poorly made screws.

Got this for my first drone build. Its well made and everything fits together well. It is pre chamfered which is nice. The carbon fiber bottom plate is kind of thin but its reinforced in critical spots with other plates. The arms are much thicker though presumably to help with crashes and stiffness. My only downside is that there is not a lot of space. There is room for a full stack in the center(with some limitations) but in the rear you are constrained by the VTX antenna cable. I'm still working out the best way to mount my VTX and RC receiver. I've flown it for a few hours and it flys well and has held up to some rough landings without any problems. I highly recommend it.

I love this frame. Will be buying it again as soon as I crash my drone.

I have several frames from Amazon. Some had really cheap hardware and caused the screws to strip out the standoffs. I bought 2 of these and I can say that the hardware with these are of good quality. Very sturdy arms. The only downfall to this frame is that the camera mounting area will only except 19mm wide and lower cameras

I printed and build 2 drones when I first got my 3d printer - when I melted the first arm and destroyed the drone I put it in a closet for 2 years until I happened upon this frame - I have been thoroughly impressed with the strength of the frame given its size - I dropped it once from about 12 feet when a battery bit the bullet (they've been sitting as well) and was happily surprised to see no damage had been incurred. The dual mounting patterns on the middle and rear of the frame were great, I printed some antenna mounts and adapter plates to make use of both of these and keep the inside of the frame looking nice and sleek.

SOLID !!!!

Doesn’t come with instructions(not a problem unless your new to the hobby), pretty easy to assemble good quality

got ran over by a car and protected the drone components perfectly. was mostly in tact. fits my massive axis f7 fc stack too