GLL 50W 6Ohm LED Load Resistors for 1157 BAY15D LED Turn Signal Lights (Fix Hyper Flash, Warning Cancellor) with 8pcs Quick Wire Clips, especially for 1157 White/Amber Switchback LED

Shipped very quickly with Prime shipping for free. Items just as described. 4 heat sink resistors with 4 crimp style splices. After researching installation on YouTube I installed the them on a set of after market LED tail lights on a project truck to fix hyper flash. They worked well and are priced very competitively. The only issue to installation is identifying the right wires in the harness. The splices make the connection very easy. Over all good product, good price, fast free shipping, easy installation. What's not to like.

Very easy to hook up on most blinkers it has 3 wires brown in the middle is not used, so one end of the resistor to the black and the other end to blue yellow or purple whatever the other wires color is very easy on my HHR

I bought these for my bike to use with my led lights so they worked probably. They work like they should and they solved the problem with hyper flash. Easy to install

Installed new LED taillights in my truck and had hyperflashing with my turn signals. Installed this in-line and it eliminated the issue. Easy install.

Excelente producto

Ford expedition 2001 is not liking these, use a LED flasher relay under the steering wheel instead!

The quick blinker on my van finally got on my nerves enough to put these in. They were faster to install than I expected. Quality seems good.

Could not. Get them to work on my truck was not your problem. Thy look great

I had very short wiring on my rear turning lights. The first time I've ever worked on wiring. Bought a multimeter to double check. I was using the right wire. How to buy a fine screwdriver to put in the batteries! What product works as advertise. Don't forget to attach it to metal!

These LED Load Resistors, do get really hot. DO NOT INSTALL them on plastic or near wiring. Simply screw them onto a metal part of the car, away from plastic and wiring. I have a 2017 Jeep Compass. For the front I just used a self tapping screw onto the side of inside of the engine bay. For the rear, since I had no real room to install them on metal, I just left them dangling away from wires. So that way the air cooled them, and after 6 months, no issues. The one time I did have an issue, was when my front right started hyper flashing. So I took a look, the bulb was fine, but the resistor connection had gotten contamination from dirt and water. So I redid that, and no issues at all since then. I just hate how people gve a one star because they get hot. Well duh, what do you expect, its a resistor.

Mais devient chaud.. installer dans un endroit libre, mais pas collé sur un fil..

Bought these to replace the cheap factory box style resistors that came with the taillights. They fixed the hyper flash on my lights and a decent value. Would recommend.

Was the right replacement part, as expected.