Specification: Model 110V Input voltage 110V 50/60Hz Input current 7A Output power 500-900W Output voltage 45V Output current 180A Tool Safety: 1. Before plugging in the heating inductor, make sure that the outlet voltage supplied is compatible with the voltage marked on the label and within 10% of the stated voltage. An outlet voltage incompatible with that specified on the label can result in serious hazards and damage to the heating inductor. 2. Ensure attachment is securely located. Coil and main are firmly tightened before use. 3. Do not use the heating inductor for longer than the stated duty cycle: 5 minutes on followed by 5 minutes off. The main circuit board has an overheat protection device, however the attachments do not have overheat protection so should not be used for more than 5 minutes of continued use. 4. Please ensure that the cooling fan is running when the power switch is operated, if the fan does not run DO NOT use the heating inductor and contact us. 5. Do not attempt to create more than 4 coils when using the flexible soft coil, a minimum of 2 coils and a maximum 3 to 4 coils is the optimum number needed for best operation. 6. Do not leave the coil plugged into the HBR mains when not in use. 7. Do not attempt to repair the HBR by yourselves. Please contact us. Operation 1. To prolong your heating inductor, leaving an 10mm air gap between the coil and the work piece is recommended as the insulation of the coil will eventually burn through if held directly to hot material. 2. Choose the appropriately sized coil to give the closest fit to the work piece. 3. Insert both ends of the coil into the coil location socket and tighten the thumb screws securely. Products shipped by US warehouse
P**.
Well made
Works well
Trustpilot
3 days ago
1 day ago
