NanoskinHD CUT Heavy Duty Rubbing Compound 16 Oz. - For Auto Body Shop, Car Wash, Car Detailing & Buffing | Removes Heavy Sand Scratches and Oxidation from Painted Clear Coat and Gel Coat Surfaces

Used this on the left side section of the hood of my 2004 Sierra. From left fender edge out to body line, approx 1/4 of hood width , front to back. I did this to show the difference of the polished left side compared to the untouched rest of the hood. I bought the truck new and it has never been compounded or polished. I first tried using the FIRST CUT and it wasn't getting off the heavy weathering, water stains, overspray, and other various defects which built up over the past 13 years. Hoods take the Brunt of paint weathering but this HD cut took care of it with ease. Work very nicely and I did Add Water a few times to keep it moist. You can see the difference and how clear the section on the drivers side edge to the body line is compared to the rest of the hood. The reflection is super shiny and Crystal Clear. I used this HD compound and then the COMPOLISH afterward and that is it. I used a 3M 9 inch single sided compound pad with the HD and same but polishing pad with the COMPOLISH. I have a Craftsman 7-inch buffer and I used it on speeds 2 & 3.

Works good if used properly. Spread with very slow speed, continue to polish. Bought both heavy compound and fine polish. I had a lot of work to do on a budget. I would purchase again for daily budget projects.

Good

It delivered in a bad way with led is loose and spill inside the ziplock yes I could returned it but unfortunately I need it

I did a cheap paint job on my car and did not want to spend 30$ for 3m compound. Found this product on Amazon with no reviews and took a chance on it. I was not expecting much for $9. I sanded the car with 1500 grit and 2000 grit wet paper. This product was able to remove some of the sand paper marks and produce a shine however there were a lot of sand mark still visible. This in my opinion this product works best on non wet sanded clear coat/paint. It is more like a machine wax and less like a rubbing compound.

Good product work great.

The top on bottle was off ,not an noth in the bottle to use.

If this is Heavy duty I think they could use a extra heavy duty version. My boat's gel coat came out great. Less is more when getting fast results. It really left a very good gloss finish, not really any need for a finer compound after this one. BUT with the boat i did end up using 1000 and then 1500 wet sand on one side to get the super heavy oxidation and scratches off first, but on my 20 year old RV this alone did the trick for the sides and two passes were needed for the front.