Drill America - POU0-80 #0-80 Tap and 3/64" Drill Bit Kit, POU Series

I bought this to change the oil in the PTU of my Ford Edge 2007. It did the job perfectly and cut the threads easily. I changed the oil and closed it with the plug. Excellent!

Had broken battery post on golf cart, used this and a threaded insert to repair. Bit worked great, just have to drill slow in lead and clean the filings out as you go. Tap worked well, again went slow and cleaned as I went. Cart is now going again.

Fantastic quality, i was shocked at how well this tap cut. I dont think ive ever had a tap this high quality. No forcing it or cranking on it or any risk at all of breaking it. Drill bit was extremly share and strong as well. Great price and im happy. I bought 2 in case i broke one and will be returning the second. The first one is practically new aftering tapping. Great quality 100%.

Good product. Good price. But the reason for 4 stars is that I found this one to not last quite as long as some others I purchased at a hardware store. They broke pretty quickly unfortunately. But they did what I needed.

Worked great

Works great, very good drill bit

I had four holes I needed to tap in 1/2" mild steel. I should have just bit the bullet and spent the money on a good tap instead of trying to cheap out on this one. The drill bit wasn't even hard enough to drill through mild steel and had to use a different bit that was 1/64" smaller to get the job done. After drilling out my four holes I tried going back to shave off that extra 1/64" with the bit that came in this kit, and all that happened was the steal marred and flattened the cutting surface of the drill bit. I should have known better than to continue but I foolishly went ahead and used the tap itself. I was able to carefully tap the first hole by backing out after every quarter turn of cutting and clearing the flutes of the metal flakes. I should have stopped there since the tap was flexing a lot (even when stopping every quarter turn of cutting). I got about half way through my second hole (using the same method) when the tap miraculously snapped in half leaving half of the tool still in the hole. I should have known better but I am furious at how terrible the tap performed. If you need to tap holes in plastic, or aluminum, or something softer like sharp cheddar, this product is for you. If you want to use it for actual work look elsewhere. I've sinced purchased some real taps from McMaster-Carr and a tap extractor. I'll never buy another product from this company again. I've learned my lesson. Buy once cry once.

I used this to clean out the mx6 1.0 nutserts for my Jeep Gladiator to install a bed-mounted tie-down system. The built-in nuts got 2 part epoxy bedliner into the nut holes. This reamed out the threads almost perfectly, though I did notice some metal filings with the epoxy powder. Slow and easy is what works best when using an ite, like this. I did not use the included 5mm drill bit.

nice matched set, worked perfectly for my needs.

Works great. Delivery was super quick!

did the job fine. Right sized drill for tap

I feel a little mislead with the company name of the manufacturer being listed as Drill America, and them only listing Miami Florida as their place of business. I was expecting a made in USA drill bit and tap for the price. $20 for made in China tap and drill bit is a of rip off in my opinion.

Update: Read first review underneath but I went to princessauto and got a drillbit for $1.49 that did the whole project with no issue. Tried this tap and it was just as bad as the drill bit, had to go buy a different tap as well. DO NOT BUY! Drill bit is weak and can't drill through anything. I didn't even get to use the tap yet because the drill bit is the worst quality I have ever seen and broke almost immediately. Read the other reviews, many people had the same problem, I shouldn't have ignored all the problems that were listed. Complete waste of $8, DO NOT BUY!! YOU WILL REGRET IT IMMEDIATELY!!