SYLVANIA 2721 Long Life Miniature Bulb, (Contains 2 Bulbs)

Very good product

Perfect fit for 2012 Honda Accord shifter light. It took me an hour to finagle the light bulb socket back into the shifter cover. I eventually popped off the shifter cover (took the shifter handle and button off, two Phillips screws after you pop off the black plastic cover, shift as needed to allow cover to come off), loosened the electrical wires for the shifter light, installed light, then installed shifter cover and then rerouted the shifter light electrical wires.The center console cover just pops right off. Start from the rear of the cover and move toward the front of the car lifting up on the edges.Good luck!

I used in my Jeep Wrangler and I laughed at easy to install. I had to take the top off my jeep and put a 2x4 with a ratchet belt to get the gear shift nob to pop off to remove the center counsel to get to the area where you replace the bulb. Which worked like a charm without getting yourself knocked out doing it but easy would not be how I would describe it. After all that, I dropped the first bulb into the recesses of my jeep, never to be seen again so good thing there were two. It worked as advertised and hopefully I never need to replace it again.

I bought these in November of 2022 for my 2010 Mercury Mariner. They fit perfectly, so that is 5 stars. However, they went out in under 2 years, so that seems like too soon to me, so 4 stars. I just put in the 2nd bulb, so we'll see how long that one lasts.

These bulbs worked fine as replacements for the burned-out backlights on my climate control panel (temperature/fan speed/air recycle/vent selection dials on the center console). I have a 2012 US Fiat 500c but gather from forums these will work in other models/years too. Takes about 15 minutes to install all told. For reasons described below I wound up needing to order a second set of the bulbs and found another seller (HELLA) with faster shipping for a similar price, though, so maybe check around.Installation protips:1) turn all the dials completely to the left or right before starting so you don't lose the dial position alignment2) the panel cover with the dials just pries off but took more force than I expected, a padded screwdriver helps (panel snaps back on easily after)3) use tweezers/pliers and pull straight out on the old lights, don't try to squeeze the plastic tabs next to them (light gray in my black car; one tab broke when I tried and I had to kinda wedge the light housing in place with a pebble, oops)4) keep a good grip on the replacement light with tweezers/pliers when pushing into place, I wound up dropping one into the lower part of the center console and had to order a second set (also oops)5) it's a good idea to replace both when one burns out so the second doesn't burn out after you've reassembled everything

Great

These were for the shifter knob light area, again order the correct bulb and it will fit.

Good replacement for burnt jeep shifter light.