CAMITLLI Cord Hider Cable Concealer, 142in TV Cord Cover Wall Raceway Kit Paintable Cable Hider for Power Cord Ethernet Cable Including 16 Connectors 9X L15.7in X W0.83in X 0.4in, CA01 White

Nearly impossible to install. Corners curl no matter how gently you try to trim it, which then makes it super hard to put the cover on. The pieces that join 2 strips must slide on and can’t snap on bc of a little “L” shaped clip inside that must slide on. Did 1 side of room by installing backing and then trying to get the cords I was hiding to obey as I tried with all my might to snap the tops on. The other side of my room I snapped them all along the cords I was hiding and then secured to my baseboards. Was better but still not easy.From a TV on a wall and down behind a dresser would be easy and you have gravity on your side, but linear across baseboards was a nightmare. There’s got to be a better product out there. I didn’t research long enough. I wouldn’t recommend.

I love the fact that it doesn’t require drilling and you can just tape it to the wall. Easy, fast, clean job.Two days after writing the review above, the tape came off the wall and keeps on falling off. I am not sure if it's due to the fact that the wall isn't smooth, but if that's the case keep that in mind.

The media could not be loaded.  When it comes to installing this, figuring out where you want your cords to go should be done first before installing these pieces together. Once you have that figured out, using these is really easy to do. There are pieces in this pack that allow you to T off cords to either come together or go in separate directions, extending the covers with a coupling, make them turn or go up or down and then one that allows you to go around corners of your wall. As you can see in the video, putting these extra pieces on is really easy to do but once you have it installed with both a top and bottom piece, it is a lot more sturdier than what is shown. Even with the extra pieces that hold the longer ones together, they have separators that not only help hold the cords in place but protect them from being bent and moved around. Once you have the top and bottom connected, the cords may move around a bit but nothing too bad. What's nice about these covers is you can either leave them the white that they are or you can paint them. Versatile and helps keep wires untangled yet keeping them all together.

CAMITLLI Cord hider works great! They were super quick and easy to install.Since we have a big extension cord, I was worried the cord covers would stick out too much or not look good. These cover the cord great and I hardly notice that they’re there! It took less than 20 minutes to install these. The adhesive on the back of these strips sticks well without falling. Overall I'm happy with my purchase!

Yes, you can fit three cat5E ethernet cables in the channel. 90 degree turns are tight but you can make it work.Do you not trust the tape. It will eventually fail, it always does, probably about two years down the road. The plastic is soft enough that you can drive a screw right through it.

I love the clean, white color of this product. However, to get the pieces to snap into each other was difficult. If a wire is thick or heavy, the grooves that they provide are simply not long enough or deep enough to hold the product together well. I ended up using gorilla glue between the joints to get the joints to stick together and stay in place.

Easy to use, plenty of parts included for my needs. 3 cords can put in this cord hider, that would be enough for me. I used my miter saw to trim some pieces to fit and it's all good. No more complaints, my walls and floors look so clean I don't even realize there covers are there, and mostly I don't see cables all over the floor. I would buy this product and take on the project again.

I received NO INSTRUCTIONS. Not knowing what I was doing lead to preventable mistakes that cannot be corrected without ripping paint off walls.