Partsam High Mount Stop Light 3rd Third Brake Light Replacement for Ford F150 F-150 2004 2005 2006 2007 2008 Smoked LED Rear Cab Roof Brake Stop Tail Cargo Center Light Lamp Black Housing w/3 Plugs

Works well

The Partsam High Mount Stop Light has been a fantastic upgrade for my 2007 Ford F-150. As a DIY enthusiast, I always look for reliable and easy-to-install parts, and this brake light certainly met those expectations. Installing the light was straightforward. The fit was perfect, and the included three plugs made the connection process a breeze. The smoked LED design gives my truck a sleek, modern look, which is a nice change from the stock light. Functionality-wise, the brightness is impressive. The LEDs are much brighter than the original light, significantly improving visibility and safety. I've received a few compliments on how sharp it looks, and it's good to know that other drivers can see my brake signals clearly, even during the day. One minor downside was the rubber gasket. It seemed a bit thin, so I added a bit of sealant to ensure it was fully waterproof. This extra step wasn’t a big deal, but it’s something to keep in mind. This light has been a solid investment for my truck, blending style with improved functionality. It’s a great product for anyone looking to upgrade their F-150’s brake light without any hassle.

Se fundio la mitad con las lluvias, hizo ver mejor a mi camioneta pero no volveria a comprar..

This is very nice fit is perfect a low cost up grade

Shipping was fast and item was packaged good. Installation is simple and straightforward. I like the plug and play design, just make sure you lay the old down beside the new so that you install the gasket correctly. Also pay attention to the layout of your wiring harness so that you plug the new light into the correct orientation of the factory wiring. Make sure you put the gasket on before plugging up the wires because once they’re plugged in they are in good and tight . I recommend cleaning the area after removing the old fixture and there are two little screw washer gaskets and it’s best to use the screw head to push them down into the holes to keep them from twisting up when the screws go down and tighten. And I also used the large piece of gasket flat waste material down inside the opening in the roof to prevent any rattling of the old light bulb plugs. They are bright and made well, you do have to use the original screws. I think it looks great and will post if I have any trouble but so far I’m happy with my purchase. Haven’t checked it out yet at night but confident they are brighter than factory.