ONELIGHT Decorative PVC Line Cover Kit for Mini Split Air Conditioner and Heat Pumps Systems,Air Conditioner Pipe Insulation Outdoor （3 inch Wide）

Easy to install and makes hiding your lineset a snap.

I have a Mr Cool 24000btu unit, with a 25 ft line. I needed two of these kits to run the full length, but they did the job.It wasn't the easiest job, though. The size could be a bit bigger to allow for the pipes and the insulation that they were wrapped in. I had to really work to get the top sleeve to slide into place. But, with effort and a few tools, I got the job done.If you, too, run into this problem, a short scrap of 2x4 or 1x6 and a hammer works great. Just be sure to keep it flush with the end of the edge of the plastic, or you'll crack it.

The corner fittings are white and the long sections are off white. They don’t match at all.

I didnt like that the downspouts are beige and the remaining parts are bright white with a lot of molding flashing to remove. The attachment screws are long enough but so small head wise and counter sunk and no pre-drilled holes but that could be a plus....I see screws easily pulling through the plastic...use appropriate screws. It is able to cover the copper pipes and drain tube but not a lot more. The flexible tube must be available prior to hooking up your refrigerant lines or its useless. The corner parts are too sharp for bending the twin copper tubes and there is a danger of kinking them. A larger radius bend would be better. It needs someone to think this through with experience. Its too expensive for plastic to be so poorly detailed. ( the parts are cast nicely but not well thought out. )