1-1/2" Wrought Iron Patio Furniture Feet Caps - Round Plastic Outdoor Metal Table and Chair Floor Protector Glide Replacement Parts (24 Pack)

-Worked out great. Didn’t need soften them up - but left them in the sun on purpose while scraping out the original ones with a paint scraper followed by a stiff bristle brush to ensure all the dirt / pollen was removed. Did six pieces/24 legs without any issues.-While folks recommended pliers to fasten, i didn’t need them. Instead, once i was able to get them attached i’d flip the chair / table back over and use the rubber mallet method with a block of wood to avoid damaging the paint and to have them permanently snap in place.-I did have one deformed metal caster so I ended up siping one cap to get it to insert… then tapped like the rest of them.-So, _rubber mallet or sledge, _block of wood, _box knife, _stiff bristle brush, and a _scraper. Easy work- :20-:30 min tops for all six. Would recommend to anyone.

These fit our chairs perfectly after we soaked then in hot water and used a rubber mallet to get them on. It made the wrought iron chairs seem like new because they glide easily on the wood floor of the deck now. I'm so happy to have found these at a reasonable price.

The caps worked like a dream lined them on the metal disc and tap with a hammer done, NO more rust rings on the concrete plus they snap in they are in and not lose. great item

All but one tapped easily into the bottom of my 1 1/2" ID chair and table legs cup. Product not at fault, the bottom of the leg had a little bit of wear ( Internal Burr) from not having a cap for couple of yrs. All I had to do was de-burred the ID of the leg and the cap then installed correctly. Not as thick of material as I thought they would be. My Original leg and table caps are15 years old and only 8 of 20 of them needed replaced. Have to wait and see how these wear on Cement patio..

The delivery was delayed, and I was about to cancel the order, but I’m so glad I didn’t! I ordered the Deluxe Version. The quality is great, they fit perfectly, and it was a breeze to install using a hammer. Now, the chairs slide so smoothly on the patio deck floor, leaving no scratches behind.

These worked well for my patio chairs. Snug going in, but that's what you want. I used a block of wood to tap it in securely and so far so good.

Measure the opening of the chair feet carefully. The plastic of the original caps was slightly rubbery, and that softness allowed the caps to fit. The plastic in these caps is harder, with less give than the original cap, and they did not fit in feet with an internal diameter of 1 and 15/32 inches.

An important part which is very hard to find Thank you