iMounTEK Electric Dog Fence System Electric Fence for Dogs Pet Tone Shock Boundary Containment Water Resistant Collar Receiver for Small Medium Large Dog

This is a very cheaply made product. The first unit arrived dead (DOA). I opened the unit to see if it was something simple I could possibly fix and found a very simple electronics board. The dial increasing and decreasing the unit's output was defective and could not be replaced. The second unit arrived, and it would power on. I found with the second unit that the distance to the fence before the corrective shock was applied was not constant. In some areas, I could walk right up to the wire without any shock occurring, and in other instances, the unit would begin shocking when I was nowhere near the fence! I could then return to the area of the fence where no shock was applied earlier and the unit would start working. There is not, to my knowledge, any type of safety restriction on this unit that will force the collar to stop shocking after a certain time period (typically 30 seconds) as you find on other units.I admit that it is possible we received a second bad unit, but if we did then the quality control for these units is not worth the possibility of severely hurting our four-legged family member. I can NOT recommend this product and suggest you spend a little extra money on a better unit.

This fence works good for the money. Don't have to bury line to deep.

Did not work. As soon as I turned it on it kept shocking my dogs even if they were inside the area. Quality isn’t good.

Didn't work for my big Bulldog but may work for a smaller dog

The original wire that comes with the unit is trash. You can read the instructions on this thing and you won’t get anywhere. If you bury that original wire at the depth they state, your dog has to drag it’s neck on the ground for the collar to do any effect. Keep in mind the controller is on the highest setting. It works a bit better if you don’t bury it, but in my case I needed the wire to be buried due to cars running over the wire. So after spending all morning trying different types of wire, I found welding wire works the best, it has no insulation so the signal is stronger. It’s the best I could find in my shop. Aside from that it’s doing great, my German Shepherd respects the boundaries a lot more now. I did find that if the dog runs over the boundary the unit will not have any effect. The dog has to be walking at a normal pace for the warnings to occur.

What a piece of junk, shocks my dogs constantly when inside the containment area. I couldn’t say less about this absolute junk. They probably won’t refund money either after we’ve taken the time to bury 1000’ of wire, so we’re out that time too. I’d give it no stars, but I’m forced to give it one. Notice how the manufacturer has not contacted any of the people writing these honest reviews about it being junk.

Works perfect. I’ve had it a few months and it’s worked great.The line is cheap and so some of my smaller dogs tend to tear it up. But it’s really easy to fix if it happens.(I didn’t dig a trench so that’s my fault. Haha)

After installed according to the directions, the collar would fail to activate. I would beep within 2 feet, but unless it was inches away from the wire, it would not shock. My dog quickly figured out he could jump over it and not worry. He also was able to break it off very easily. The collar has to be very tight for the shock to be effective.

La verdad no funciona si emite sonidos pero no descarga toques cuando el perro pasa el cercoYa se acostumbra al sonido y se pasa

NO L O USE EL PERRO SE PONE MUY AGRESIVO