🚀 Elevate Your Drive with Ecogard!
The Ecogard XA5432 Premium Engine Air Filter is designed to fit a range of Toyota and Lexus models, ensuring optimal air flow for improved engine performance. With a factory fit for easy installation and a recommendation to replace every 12,000 miles, this air filter helps prevent engine wear and enhances your vehicle's longevity.
Manufacturer | Ecogard |
Brand | ECOGARD |
Model | XA5432 |
Product Dimensions | 32.26 x 20.07 x 4.83 cm; 181.44 g |
Item model number | XA5432 |
Exterior | Machined |
Manufacturer Part Number | XA5432 |
OEM Part Number | ACDELCO A2933C, FRAM CA9360, PUROLATOR A35432, TOYOTA 17801-0H010, 17801-20040, WIX 46673 |
Item Weight | 181 g |
N**R
Did not fit.
It suppose to fit 2010 camrey, but the one i received is bigger than old one, it did not fit in my car.
N**A
Fits Camry 2005, 2az-fe
Perfectly fits Camry 2005, 2AZ-FE. Original price for this filter is around 9 bucks but taxes and some fee... and we have what we have.
M**S
Fits 2009 Toyota Sienna. Read the latter part of my review for instructions no matter your vehicle.
I bought this for my 2009 Toyota Sienna. It fits perfectly and the quality seems okay. The following are my instructions for a 2009 Sienna in case you've never replaced the filter before. Even if you do not have a Sienna I would still advise you to read my instructions as the latter part will still apply no matter what make and model auto you have.You'll need a 10mm socket attached to either a drive spinner, extension rod or something similar in order to loosen the two bolts located on the right side of the housing with one in front and the other on the back side. My 6-inch drive spinner was a perfect size to get to the bolt on the back side. Notice I said loosen as they do not need removed. Also, you'll need to disconnect a few air hoses on the left side of the housing in order to lift the housing away enough to pull out the old filter and put in the new one. TAKE NOTE, if you lift the housing too much it will cause the two connection points on the left side to disengage and you'll wonder why you cannot replace the housing to its original tight seal when you put it back together. It’s no big deal if you do. Just angle the left side of the upper housing downward enough so the two connection points on it can slip under the opposing connection points on the bottom housing (see picture).Now the MOST IMPORTANT THING: the filter has a top and bottom and a front and back. Please look at the attached pictures. You can see the old filter with the printing on it to guide you unlike the replacement filter. The easiest way for you to know which side and direction is correct is to look at all four corners of the filter. Only one of the corners comes to a sharper point than the other three. That corner belongs to the front right. Once you've got that right and put it in place then, of course, it's just a matter of putting it all back together. Again, remember what I said earlier about the connection points on the left side of the housing.I hope my instructions save someone a little time, effort and headache.
Y**Z
Nice one
It looks good
M**E
Perfect fit
Nice air filter, fits my 2008 Toyota Highlander 3.5, well made filter that fits perfectly. Satisfied customer.
C**
Just as good as other mainstream brands
For 3 years now I only use their filters on my cars both on in cabin and engine and they work great. Highly recommend them
Trustpilot
1 week ago
1 month ago