[5 Pack] BESTTEN 2-Gang Screwless Wall Plate, USWP6 Snow White Series, Decorator Outlet Cover, H4.69” x W4.73”, for Light Switch, Dimmer, GFCI, USB Receptacle

They look great and seem nice and strong install was a snap

Not clean and also have slightly scratches

I bought 5 different types of double gang box screwless plates. These were the best match and easier to install than others, which I returned.These are the largest I could find at a reasonable cost, which is what I wanted. They are true to size and color match close enough to my smart switches (Treatlife, which I highly recommend). The slightest shade difference is not noticeable.Pro tip: tighten the back plate down before tightening the switch screws so you can make slight adjustments - and frankly its easier to install that way. I learned this after the 2nd of 5 installs.

As can be seen in the photos the color “Snow White” is not consistent across products.

Once installed, these switch plates have a really clean look. The only reason I didn't give them 5 stars is they're not as matte as I'd like, and the directions really leave a lot to be desired. Here's how to get the best results:1. Remove the old faceplate and LOOSEN THE SWITCH (or outlet). Reason for this, is this new faceplate is thicker than the cheap ones you're replacing, and loosing the switch will allow it to sit flush in the end.2. FLIP THE MOUNTING PLATE AROUND and screw to the switch. The mounting plate is shipped inside the faceplate backwards. This is why some people mention a gap or that the faceplate doesn't attach properly.3. Now retighten the switch's screws to snug the entire unit to the wall. Don't go too tight, or else the switch won't be flush with the faceplate.4. Pop the faceplate on. Sometimes, especially with the multi-switch plates, it can take some effort to snap every tab in place. Listen for a snap to endure it's on tight. Removal is easy, by sliding a flat-head screwdriver into the slot underneath.