VOFONO Early Bus Wiper Cowling Rubber End Pieces for 2004-2008 Ford F-150 and 2006-2008 Lincoln Mark LT

Great Product, easy to use

My original parts deteriorated and fell fell apart. I check with a body shop and was told the new parts would cost $200.00 to buy and install. $12.00 and 30 minutes ofy time.

Fit good

Didn't fit exactly, required auto glue

Cowls were easy to install and came with securing pins. No instructions but simple enough to figure out especially with the “L” and “R” on the backs of them. Quality product and looks great.

...unless a product is so bad, I feel compelled to try to save someone else the hassle.Firstly, they're not rubber, as it clearly states in the first line of the product description. They are very flimsy, cheap, plastic. The driver side one seated and fit my 05 F150 ok. The passenger side was no where near. The clips that you are supposed to use to secure it with are too small and thin to hold anything in place. They don't lock because of the thinness of the tabs. Their "locking tabs" are so flimsy, they curl under on their own. I drove with them today after I installed them. I got up to about 60 mph on the way to the V.A. 30 minutes away. The passenger side had come loose and was being held in place by one of the tabs. Not a good product. Go to a salvage yard and get some.

they *(one for each side) fit just like the first ones. lucky i still had the clip remover i needed to get the old clips out and long nose pliers to align the leading tab; but easy peasi otherwise. apparently i need superglue to keep high winds and rain from blowing the right one out. won't happen again.

Installed them on my 07 F150, used sidecut pliers to remove the push pins. After removing them I noticed a small bead of silicone on the very small lip of the fenders. Cleaned the silicone off, installed the new cowl end pieces used needle noose pliers to pull the small curved pieces thru till they were set in place then I applied a very small amount of exterior silicone to the small inner lip of the fender approximately 1/8" bead by 2" long, pushed down on the new pieces and installed the push pins. Let them set all day to cure the silicone. They fit very nice and look original. They shouldn't blow off with the silicone as an extra bond. Took about 30 minutes start to finish to do it the right way. I highly recommend this product from the seller.