8" Dualie Plastic Omni Wheel Specifications: Diameter: 8 inches Width Across Middle: 2.04 inches Width Including Screws: 2.22 inches Bore: 1.125 inch diameter bore, 1/4 inches deep on either side, 0.95 inch diameter thru hole Bolt Pattern: 6 hole on a 1.875" diameter bolt circle Body Material: Black Polycarbonate Load Capacity: 120 pounds (rollers don't spin pas this weight) Weight:2.2 pounds Number of Rollers: 36 Roller Material: Black SBR Rubber Roller Durometer: 80A Roller Bearing Material: Brass Roller Axle: Steel Dowel Pin Roller Diameter: 3/4 inch Repairable by removing interior #10-32 screws and perimeter M3 screws Included Hardware: Four - 8" Plastic Omni Wheel Webs Thirty-Six - Black SBR Rollers Thirty-Six - 1x1/8 Steel Dowel Pins Seventy-Two - Omni-roller Sleeves Nine - Individual M5x0.8 x 20mm SHCS Twelve - Individual M5 Nylock Nuts Three - Individual #10-32 x 2-1/4" SHCS Thirty-Six - Individual M3 Nylock Nuts Thirty-Six - Individual M3 x 10mm SHCS Usage: With Axle and Hub: If you wish to drive this wheel with an Axle and Hub, you can pick your hub by fitting any of the AndyMark hubs (except the Small DD Globe Hub) to this wheel. Hubs are NOT included in the price of the wheel. If this is your choice, then no bearing is needed. To install a hub onto this wheel, longer screws will be needed to replace those on this wheel (3 or 6 of them) With Sprocket: If you wish to drive this wheel with a sprocket, then the sprocket needs to be attached to the side of the wheel, and one ball bearing needs to be pressed into the wheel (on one side). For 1/2" id, use two am-0029 bearings and two am-0030 bearings. For 3/8" id use four am-0209 bearings. With Bearings: One ball bearing needs to be pressed into the wheel (on each side, totaling 4). For 1/2" id, use two am-0029 bearings and two am-0030 bearings. For 3/8" id use four am-0209 bearings
Trustpilot
2 weeks ago
4 days ago
