4 Row Universal Aluminum Automatic Transmission Oil Cooler Kit Ultra-Cool Tube 402 with Installation Accessories

I'm using this to cool down water instead of oil, but it's been smooth sailing. No leaks. Reasonably well made. The fins are not supported on the end by a frame and are only held in place by the tubes. There's plenty of room to fabricate your own mounts, or just use the big zip tie things. It was also insanely inexpensive when I bought it.

I don't think I have a big car (Nissan Rogue) and the hose is really enough to run one side to go to the cooler from the transmission. So, go get another 3-4 ft of this hose before you start the job. Also, while the hose is perfect fit on the transmission side fitting, it's super tigh and very hard to slip into the cooler side even I used some trans fluid as lubricant.

Tried installing this cooler with the supplied clamps but the clamps provided are so thin that the first 2 stripped out when I tried to tight them. No, I did not over tighten them, they are just so thin and poorly made that they wont hold up to even light tension necessary to install them I'm really sorry I purchased this. I hope the cooler itself is made a lot better than these cheesey, worthless, piece of crap clamps. I already had to do the job twice due to the leaks from the clamps and it's a big job due to the location of my lines

Arrived in thin unprotected box, it did not include any of the accessories shown in the ad. No hose, fittings, clamps, straps...nothing but the cooler itself; how am I supposed to install this? when it clearly states includes all needed accessories.