Front Left and Right Stabiliser Anti Roll Bar Drop Links for Aygo Yaris Peu-geot 107 108 C1 4881952010

I recently purchased these stabilisers to replace my old Peugeot's ones and they were a perfect fit. worked as intended. I have no complains at all. Recommend this seller and this product.

I ordered this for my Aygo 2009, 1 cm longer than my Aygo 2009.

This worked very well

Slightly longer than original, but can be fitted without removing ball-joint.An extra jack under the suspension arm increases the space between drive-shaft and lower arm. Then lever the anti-roll bar up.I did find that by fitting and tightening the lower nut before putting the top through the anti-roll bar it was easier - as it squashed the lower mounting rubber and reduced the gap needed.

These were showing as compatible with a mk1 aygo which is the same as a C1 and 107, fortunately I've jacked the car up on stands removed both drop links off the car to find these are too long and ain't for the car in the fitment, theirs also an extra rubber, whoever manufactured these clearly needs to go back to the drawing board and figure out what car their ment for as I can't return them now as I've had to reuse the old bar and fashion up some of the new rubber of these with old and go and buy another set to do the whole job again, frustrating to say the least.

Other reviews here say the parts do not fit, that is because they are an upgrade from the standard part and have extra rubber, hence the extra length of the threaded shaft. To fit them, you MUST disconnect the bottom ball joint under the hub and disc to allow the extra movement of the wishbone / lower suspension arm. Even then it’s a hard job to get them in and the nuts started on the threads, but it can be done. It’s made harder if you’re lay down under a car on axle stands as you can’t get the leverage or find just the right position to work comfortably easily.

These are too long compared to oem parts

These parts do not fit, they are the wrong size for c1.