AmeriLite for 2011-2013 Jeep Grand Cherokee WK2 LED Tube Smoke Black Replacement Tail Lights Assembly Set - Passenger and Driver Side

The media could not be loaded. To start off, the lights were easy to install. The plugs are direct fit for the 2011-2013 WK2, and the pieces snap in/out or are held on by one or two screws. The LEDs are bright, look sleek, and were exactly what I was looking for to upgrade the stock halogens. The reverse lights are halogen, but much brighter than the stock. They perform well and have a nice profile, especially at night.I posted several photos from different angles and times of the day so you can get a sense of how they look in different lighting. One photo also shows mid-install, so you can see the difference between the stock and Amerilite.I’ve had them in for about 2 months now, and I wanted to wait to post a review to ensure there were no water leaks or issues with LEDs burning out before posting. They’ve held up fine so far. If they fail or burn out, I will absolutely be updating this review. As a car part, they should be expected to last years at the minimum. I think one area people could be experiencing leaks from is the pressure seal on the inner taillight section. You NEED to clean the tailgate after removing the old taillights pressure seal, otherwise water can get directly in. This is the same way the stock taillights worked so it is not inferior, but needs to be installed properly so there is adhesion to keep out water or the reverse light cavity will fill up as water trickles in.My only real gripe is the price. For what they are, they could be a good amount cheaper and have a better warranty than 90 days. But since they’re basically the only ones on the market, it is what it is.Edit: 3/30/25 - I’ve had them installed for over a year with no issues. Still going strong.

2011 Jeep Grand Cherokee LimitedThe lights look great & seem to be good quality,I just installed them so if any issues come up, I'll report back here.

So far so good. All installed, plug and play, although for the rear door lights you’ll either have to remove the interior door panel or be ok with squeezing your hand in between the panel and the door through sharp edges in order to secure the OEM nuts to the new light bolt assemblies. Other than that was great.While I was at it I spliced all 3 exterior light wires and bought the (2) lower 3-wire lights that replace the red reflectors. Will post when it’s all complete.

Easy installation as it really is “plug and play” it was a little complicated finding the correct place to mount the little block but very bright and nice looking lights.I’ve had them on for about a year and the strip around the right daytime running light has gone bad. At thhe price I bought them I really hoped I could get at least more than a year of use so that’s really disappointing. Vendor said there’s nothing they could do. A shop quoted me half the price of them to fix the issue.

I absolutely love my new taillights. They do make a difference to the Jeep look on the tailgate. One light did come faulty but contacted customer service and they gave me a few options to do to try and fix and when nothing worked, sent me a replacement piece. Responded quickly too any messages as well. Will definitely buy from them again!

Good works as could no leaks

Great upgrade for a newer look and clean install, only thing is left outside lense came cracked but still completely useable, had to repair with epoxy to keep light sealed.

These are by far my best Amazon find. Very well built, perfect fit, easy install it took me about 10 minutes. And they look great! Very happy with these.