Liquid-Tight Conduit - 1/2inch 25 Foot Flexible Non Metallic Liquid Tight Electrical Conduit Kit, With 4 Straight and 3 90-Degree Conduit Connector Fittings.1/2" Dia

Wocloer Liquid-Tight Conduit – ½ inch 25 feetI purchased the Wocloer Liquid-Tight Conduit – ½ inch 25 feet kit to run wiring from the panel box to a whole house surge protector. With the kit I was able to secure the wiring according to code requirements to complete the installation. I only used 6 inches of the conduit plus two connectors to do the job for less than the individual parts would have been from my local big box store. I have over 24 feet and 4 connectors left to use on my next project. In the future this will be my go conduit for my wiring jobs.

This 3/4-inch 25-foot Liquid-Tight Conduit Kit is exactly what I needed for running safe, clean electrical connections outdoors and in damp areas. Right out of the box, everything was well-packaged, and the quality of both the non-metallic flexible conduit and the included connector fittings was outstanding.The conduit itself is strong yet flexible, making it easy to bend around corners or tight spots without collapsing or kinking. It cut cleanly with a standard utility knife or conduit cutter. The included 4 straight and 3 90-degree connectors snapped in place securely and made for tight, waterproof connections — no leaks or gaps at all.I used this for wiring a 240V heat pump pool heater and an outdoor spa disconnect, and it performed flawlessly. It met code, sealed up tight, and handled temperature fluctuations and exposure to sunlight without showing any signs of stress.It’s also nice that everything you need is included — you don’t have to run to the hardware store mid-project looking for extra fittings. The connectors are well-threaded and easy to install, with no frustrating fumbling or stripped threads.This kit is ideal for outdoor, garage, workshop, generator, or pool-related electrical installs, and at this price point, it’s a fantastic value for the quality you get. I’d absolutely buy this again and recommend it to anyone doing safe, secure electrical work with a flexible setup.Five stars without hesitation

bought this item several times because of its low price, but the quality is the same as the big brand in the big market.

I had a direct burial ethernet cable running between my house and shop to extend Internet access to the shop. That cable had been in the ground for the last 5 years, but I had recently started experiencing problems. I would get very slow download speeds while upload speeds remained normal. The cable passed a continuity test, but a length test showed it was over 300 ft, even though the actual cable was only like 125 ft. I finally decided the cable must be damaged.I decided to run a new cable between the two buildings, and this time, protect it with some conduit (I still used direct-burial cable). This conduit is quite thick and seems like it will offer good protection to the new cable. The included connectors were also quite nice. The only issue we ran into is that we buried the conduit first, pulled a string through it (using a shop vac with some plastic baggy tied to one end), and then tried to pull the new ethernet cable through the conduit using the string. However, there was simply too much friction between the cable and the inside of the conduit, causing the string to break and the ethernet cable to get stuck. This required digging the conduit back up, stretching it out straight, pulling the ethernet cable through it, and then re-burying the conduit with the ethernet cable already inside.In hindsight, we probably should have dug our trench a little straighter (there were a few minor bends, but nothing too extreme) and/or lubricated the inside of the conduit first with some talcum powder or some wire lubricant. Whatever the case, we were able to get the job finished, and everything worked well (normal speeds in the shop building) when the project was finished. However, it might have been helpful for the conduit to include some instructions and/or installation tips to help prevent the trouble we ran into, requiring us to dig it back up and re-bury it with the cable already inside.

100% waterproof, great value.

Ended up being the wrong product for the job but it was solid and well made. looked like it will work just fine but I only ended up using one part from the whole kit. My mistake not the mfg. This stuff is a great value and you get a ton of it. More then what you would need for small to medium jobs and its all fits well as it is standard size. Easy to figure out if your a novice and you can not see any design differences from the name brand parts at BBS's

No problem with the 3/4 inch version, other than some minor staining on the outside, it's very solid, feels just as good as the home depot stuff.It's also pretty easy to pull wires through, at least with the wire I use, I think those wires have an additional plastic sleeve outside to make it easier to pull, pulled three 20ft of 6awg in one go bare hand, no lube.

Good value. Worked as it should. Nice that it came with some fittings as well.