Compatible for Dymo Rhino Industrial Heat Shrink Cable Label Tubes 18055 S0718300 Industrial Labeling Tape 12mm x 1.5m, Compatible for DYMO Rhino 4200 5000 5200 1000 3000 6000, Black on White, 4-Pack

Kann man nichts falsch machen

Passen nicht im Dymo 6000+

I just finished using several of these cartridges for rewiring/upgrading our HOA Clubhouse sound and IT systems. I generated the labels using a Dymo Rhino 4200 labeler(another 5 start review to follow). Having retired I don't have access to my former employer's Brady labelers. The product is excellent and far more economical than Dymo's equivalent product. The Brady equivalent is even more expensive. Lettering is sharp and durable.If you haven't used heat-shrink wire labels before try shrinking them by heating on the opposite side of the lettering. Then tighten in up if needed on the letter side. This will make a tight wrinkle free label every time unless the label was too big to begin with. 1/2" works perfectly on standard CAT5 cable. With some of the thicker shielded CAT6's and above you might want to go to 3/4". Shrink wrap labels 1" and below will not fit over any connector.

Good product

These work fine in my cheap Dymo 160 printer. I had no idea heat shrink was even an option with it.They tend to jam if you don’t pull a little extra out when you first load it.Print quality is great and they can fit over a connector and still shrink up tight. I’ve been Putting a clear shrink tube over the top to ensure the numbers don’t wear off.