LeMotech Project Box 5 Pieces ABS Plastic Electrical Project Case Small Junction Box for Electronics White 2.36 x 1.42 x 0.67 inch (60 x 36 x 17 mm)

Box's where perfect. Good quality.

Well made and great quality. It didn't work for me because the height was just a 3mm too small.

Just what I needed and fast shipping.

Pretty good little project boxes that snap together well. There is a hole on each end for wires or maybe even an LED to poke out. I also have used a couple to hold Raspberry Pi Picos with pins when storing them so the pins don't get bent, etc. The ones that are a little bigger would make a good Pico case where you want to have a USB wire come out, you have to allow some length for the plug itself to fit inside of the case with the Pico

But they work great! My suspended desk slider needed raising juuuuuust a little bit. But not raise up so much my keyboard and mouse get squished. They look nice too, like it's part of the slider. These were a very inexpensive solution to an ergonomic problem. I used four of the five and maybe I can use the fifth as an actual container. Ha!

It's just a box. Clever snap-on lid. Dimensions are given for everything except the one dimension that's hard to measure - that is the dimensions for mounting a board. So you have to try and hover your caliper over the mounting holes. As someone else has mentioned, there are no screws for mounting the board or even any part number for the screws. In short, the manufacturer could have made our job easy but chose to be lazy and make all of us figure it out. FYI, my best guess is 87mm x 48mm spacing for the PCB mounting screws, but my eyesight isn't what it used to be. I found some screws that seem to work so I don't have a part number. And finally, the mounting posts are too close to the corners leaving too little board material between the mounting hole and the inside wall. And watch out for the inside dimension because the wall slopes and gets smaller as the board is lowered down. So, if you use their dimensions, the board will be too big and require lots of hand filing. If you make the board shorter to fit the real size, the PCB will not have enough material between the mounting hole and wall. (This review is only for the case measuring 3.94 inches outside)

One hole nees to fit romex..

Used as junction boxes for LED light bars in my barn. I didn't want a big 4" box at 8-10$ a piece. lower profile and lower cost. Worked perfect for what I wanted. Just had to drill the holes.