POLE.CRAFT IWB/OWB Magazine Holster Kydex - Mag Carrier Fits: 9mm .40 Double Stack / 9mm .40 Single Stack - P365 1911 Glock 19 19X 17 26 27 28 43 22 23 25 26 27 31 32 33 34 35 37 38 Glock43X .. Mag

Like another reviewer, I cut one of the rubber spacers in half for the clamp portion. It makes the fit extra tight. The item is minimalist, light, and sturdy.

Came in a timely manor, no printing of the mag, I love it. This is a great option for carrying an extra mag with you

I wanted an IWB ammo holster and researched and tried a number, included highly regarded and established ones like Crossbreed, Gelco, We The People, etc. The Pole.Craft was molded to my gun's magazines, solidly built, worked well, and had an overall thinner profile than the others. On top of that is was available fast and at a reasonable price. Compared to the IWB competition it is 5 stars in terms of doing it's job. But it is not perfect. I just used it for a 4 day defensive handgun training, pulling and holstering countless times all day long. It lacks padding on the inside. Who wants to have a hard Kydex shell pressing against their hip bones all day? After bruising I bought Moleskin at Walmart and added that to the body facing side. Since that is an aftermarket quick fix, it does not adhere permanently, it comes off, and it also peels. There needs to be a better permanent solution, such as neoprene that is permanently glued or screwed on to the holster or something else that adds a few millimeters of padding.

These are well built for the most part. Belt clip is sturdy, can be flipped around if desired. The molded thermal plastic is clean and shaped nicely.The downside is the retention, as shipped it was way too loose. I mucked up the phillips heads of the screws trying to tighten them, as when fully tightened the mags will still dump when held upside down, not ideal for EDC. The issue is the rubber washer used for the adjustment is 3/8" and should be 1/8-1/4" sized. My solution was to carefully cut one washers in half and use both halves on the two adjustment screws. Tightened the screws and had perfect retention. Backed them out, added blue thread locker and tightened, now they are good to go.Due to the DIY aspect, if you are handy and want a project a good buy. Little pricey considering the lift. If you aren't keen on modification, I'd look elsewhere for a p365 mag holster.

I’ve seen comments saying it doesn’t hold the mags and ect. Well, it does….all you have to do is place your mag in the holster and tighten the screws to the frame you like it to hold. After doing that my mag sits and stays in place even when I’m running or on the ground at some point. Over all 10/10 recommend for shooters!!!!

Great quality and stays on. Highly recommend.

As others have stated in their reviews this magazine pouch is slightly too large for a 17 round Sig P365 Xmacro magazine. The magazine fits well inside the pouch but has zero retention without modification. I did what at least one other reviewer said, cut the rubber washers between the tension screws in half, which made it work. The geometry isn’t molded and is a very generic fit but it gets the job done. I’m torn on recommending this as it does indeed work after modification but not sure it should be marked as compatible with the P365 Xmacro. You can decide if modification and a generic fit is okay with you.

Mag fits snug. Belt clip is stout. Good to go. 👍🏻