LIBRATON Tube Bender, Copper Tubing Bender 180 Degrees, 3-in-1 Manual Tubing Bending Tool 1/4", 5/16", 3/8", Copper Tube Bender Set with Mini Tube Cutter & Deburring Tool, for Aluminum Brass Pipes

Needed for reduced radius bends. Works well. Must! must! anchor well in a vise!! Experiment and practice on a piece of scrap tubing for marking of your bend and accurately placing in the bender. I was bending 3/8” aluminum/.035 wall tubing. Thinner wall tubing does not react well.

Bought this to bend a a decorative Oil Rubbed Bronze pipe to connect a water closet to source on the wall. The source was a about 8” from the connection on the toilet so I had to put a couple 90 degree bends in. Since it had a finish on the tubing I wasn’t sure how well this would work without damaging the finish. But I took the chance and wrapped the tubing with some painters tape before proceeding to bend it.The bends came out perfect with no damage to the finish at all. The angle references on the bender made it ease to ensure I was getting the proper angles. Great little tool at a very reasonable price!

Product was used to form a new outlet pipe for my compressor. After several attempts, I succeeded. In the handle there are 3 holes for determining actual pipe size. All 3 were smaller than noted which proved to be irrelevant.

This was just what I needed to bend new steel fuel line for my 64 corvette. I gave it three stars for ease of use because there were no instructions included for offset when making bends. Offset the amount in inches you need to add or subtract to get the finished 90* bend at the proper finish point. I learned thru practice on scrap tubing for 3/8 steel I need to subtract 2" from the desired length (positioning the bender).

I bought a more expensive bender, but it was hard to rotate the handle and it kinked my 1/4" tubing. This bender is so much better. The handle moves smoothly into the starting position and then it pulls easily around to the desired angle. Worked great on the first try. Can't say enough for how pleased I am with this bender. I'd buy it again in a heartbeat.

These are nice good for HVAC work.

Nice bender

Good

Works as expected.

I don't know how the pipe bender will behave, but I had problems with the cutter on the first day 😕😕

Piega bene i tubi in rame dell'aria condizionata

1-2 kere kullandım yaptığı iş mükemmel ve parasını çıkardı

👍