Helmet Anti-Fog Visor Insert Motorcycle Anti Fog Film - Universal Fit Helmet Visors Fog Resistant Film Clear Shields Lens Insert 27cm x 9cm

Fantastic! Replaced a broken pin lock visor in my Shoei GT Air2. Fitted last night, very simple and easy to follow instructions, fitted in about 5 minutes. Just follow the steps carefully, you can't go wrong! Used today in 4 degree weather, not a single bit of fogging up or misting on the visor. Perfect vision the whole journey (half an hour commute). Absolutely recommend.

Great item

Haven't rode with it yet but sat watching F1 with my helmet on (to test it out) and the fog is all around the side of the visor insert but not on the front. Seems like this may work. Looking forward to testing it out fully on my ride to work! Reason for 4 stars is, it says universal but I had to cut it to size, hopefully this will not hinder it's performance!

Really easy to install with clear instructions and a centering sticker, came with a microfibre cloth to clean visor before application. Very clear, can't tell it's even there. Fantastic at stopping fogging which is evident by the small portion of visor around the edges that the product doesn't cover fogging up real bad. The adhesive was extremely sticky so I don't see it coming off on its own. Mines been on for 500+ miles now and in all weathers (mostly rainy, damp days here in the uk) and it's proving to be an absolute must have for me. I honestly don't have a bad thing to say about it apart from maybe it could be cheaper considering what it must cost to make but hey, it's still cheap compared to some of the branded names which is basically the same thing.

Easy to apply, and really does stop the visor fogging up.

This product works so much better than the pinlock I’ve tried before. I should have measured my visor before order as this one was too large and I had to cut it down a bit to size but that’s my own fault. I would 100% recommend this product.

Not universal. Does not fit my Bell Broozer visor. It is simply far too large, and cannot be trimmed as this would impact the anti-fog properties. Unfortunately to establish this I have had to use the product. I should (and will now) be going with a proper pinlock system, not a one size (doesn't) fit all system.

Fitted as per instructions. The glue wasn't strong enough to hold the insert on the inside of the visor. No point in leaving it for 24 hours to dry as I could see the glue wasn't sticking as it should. Sent back for a refund. The curve of your helmet visor would need to be very slight for this to stick.