M10 x 15mm Copper Tap Tails: Tap Tails Replacement for Monobloc, Basin, and Sink Mixers

Having connected the customers tap with 9.5mm bore flexible connectors supplied the pressure from the cold was good but from the hot only just a dribble. Checked there were no kinks in the flexi connectors and the pressure was no better. Ordered these copper tap tails and the pressure was immediately acceptable. There is only about 50mm of the reduced bore on these so it lets the water through quicker. The tails are quite soft so I cut and joined the 15mm section to a piece of conventional pipe before the isolation valve. Take care when using a pipe slice.

These tails guarantee no future leaks unlike the cheap *hinese Flexi pipes which are very poor quality, and I have known them fail.

These were used instead of the flexible pipes to get a better water pressure.

Did the job. Tap fitted and all working well with no leaks

Get the maximum flow rate right up to the tap, these tails are well made and a reasonable price.

Replaced flexible tail with this on hot side. Improved flow slightly. Decent quality product.

I used these as they are a stronger flow to the taps than the flexible type

Did not work on my taps. There is a shoulder below the 'O" ring which stops the tails from sealing. As a result they leaked badly and I had to replace them. Very disappointing.