Ultra Slim Low Profile Universal Triple Arm Swing & Tilt Corner Arm LCD TV Wall Mount Bracket Black Swivel Articulated Wall Mount for 15" 17" 19" 20" 22" LCD TVs with standard VESA holes

Fixings missing, weak design.

Fast delivery, works as described. I would readily recommend. Using a 19" TV VESA 75

Does what it says on the tin! Very easy to fit, bracket stays level .even when tv pulled out and angled fully. Good value for money, would buy again.

Used to hold a 21" flatscreen Samsung TV. It was easy to assemble and fit to the wall although TV fitting screws seemed a little long.

Great item, delivered on time & well worth the price. would recommend this item for anyone looking for quality at the right price.

I bought this item in order to mount a 22" Samsung TV (VESA 75mmx75mm) in a bedroom. I needed it to mount easily to a timber frame (stud partition) wall. It took me 5 minutes to drill 2 holes for the mounting bracket and to secure the TV on the bracket. There are also fittings provided for solid walls if required. Job done. Can't fault it !!

Fixed to drylined wall so used 4" screws to get the wallplug into the middle of the blockwork. Obviously looks better if the bracket is vertical but no problem if slightly out as the bracket is fully adjustable with spring loaded screws onto a ball joint. A cheap pressed plate spanner is provided in the box but better to use a socket to tighten up the 2 bolts at either end of the main arm. Very solid sturdy bracket which positions the screen a max of 310mm from the wall.

I bought this TV support arm for a 23" TV/DVD combo. Several reviewers of various TV support arms had talked about sets sagging to the side where the DVD is, because it is heavier on that side. I noted that this particular arm had a ball joint, so that it could be adjusted to compensate for this. In fact, my expectation was exceeded because the adjustment is controlled by four spring-loaded screws which make it easy to make adjustments after the set and the arm have been installed. In my case, I have screwed it to a wooden upright and the screws provided were perfectly adequate for this. Although it is, I think, made of cast aluminium, It appears to be very sturdy and the two joints are formed by steel bolts with a lock nut. There is a little play on the ball joint holder, but you can compensate for this in the adjustment.