TeexpertCrystal Clear Epoxy Resin Kit 2 Gallon Self-Leveling Coating and Casting Resin, High-Gloss & Bubbles Free Resin and Hardener Kit for DIY Art, Jewelry, Table Top, Molds, Wood 1:1 Ratio

Fast friendly service

I've made this my only go to Epoxy Resin. I've used it for a deep pour (1") and also use it for my last pour (Flood) on all of my tabletops. No stink, virtually no bubbles after the pour and if so are minimal and vanish with a little heat, super clear and the price is right and hope it stays that way.

I was about to quit playing with resin after going through way too much money and ruined products because of other resin types. Then I tried this one and "I'm back in business, baby!"It does need a bit of work, but the results have been a resin that release the bubbles better than anything else I've tried, so to my fellow newish resin enthusiast... Here's how I've had best success:1) Measure the needed amount of each into separate cups (I use reusable hard plastic ones with lids, so I have less trash waste) and place them in some warm (not hot) water for 3-6 minutes depending on the amount.2) Mix the A+B resin in a new cup. I use an electric resin mixer and it does have to be mixed a bit longer than other ones - really look for those stringy part in there!3) Place the cup back into the warm water for 3-5 minutes.4) Pour slowly and then use a toothpick or craft stick on the sides of your product to make sure no bubbles got stuck there. And remember, the deeper the project the harder a time bubbles have releasing, so work in layers if you must.5) Do your usual heat gun/lighter tricks, and voila, you'll *most likely* have a nice mostly bubble free result!One last thing... This is a lower viscosity resin and works great in molds, but I found that it really wants to fall over the sides when used as a top layer on coaster for example (even after a 15-20 minute work time), so you may want to use it as the bottom layer and then top coat it with a thicker working resin or wait long enough till it's thickening up a good bit itself.

The packaging is superb, and the pumps work great. The problem I had with this resin is its so thick. No matter what I have to pre-stir and put in warm water to get it to thin out. However the more it had to be thinned, the quicker it became hot and sticky. I had this flash cure 3 times from warming it up. Also, so many bubbles. Alcohol didn't help. Torching was a very bad idea, so now, I've moved on to another brand. Too bad because I liked this resin in the smaller bottles.FYI, the ball has 1-2mm clear glass balls in it. Those aren't the bubbles in talking about.

While I love this product, this was a reorder. However, instead of delivering by Amazon to my house as normal, it went USPS and left in a parcel locker, that we had to pry it out of because it was sent in a bigger box with other subscribe and save items.