6-1/2 inch Plunge Cut Track Saw - Corded – Can Be Paired with 62 inch Guide Track (Kreg ACS430) – Adaptive Cutting System – ACS-SAWBB

I recently retook an old hobby with woodworking, and this Kreg saw along with its companion multi functional table were the first things I purchased. This saw has plenty of power to cut through 3/4” panel (thickest I’ve cut so far). It is important to keep in mind that when doing crosscuts, the wood can easily chip or split… my recommendation is to use painter’s tape and draw a cut line on top of the tape to guide you and to prevent the wood from splitting. The splinter guard helps, but is not 100% effective, so you still get some splinters, hence my recommendation earlier. The dust port is very effective especially if you attach a vacuum. Through the last couple of months I’ve been using this saw, I estimate an 80 - 90% dust capture by attaching a vacuum. For anyone starting out, this means there’s less fine dust particles in the air, which reduces the risk of breathing those into your lungs (which can lead over time to breathing issues). Other things I like are how well the saw works with the Kreg track, you can easily adjust the saw with the guide to virtually eliminate any play, thus allowing you to make very precise cuts. Setting the plunge depth is easy, and the saw’s handle allows for push or pull, so if you’re like me (5’ 10”) or shorter, you can start your cut on one side, pause and go around to finish the cut without leaving marks. Hope this helps

Is a good tool that works as it should.

Works as advertised. Sets up easily. Makes a perfectly straight cut. Would clamp down the track though. Blade makes a smooth cut.

The floor works great I love it

It works well and makes very clean cuts. Only complaint is that the dust control did not work well as shipped. I added an aftermarket cap to cover the arbor hole, and it works much better.

The saw is heavy duty, it can only be used with the accept track

I am very happy with this saw at a dramatically cheaper price then a Festool. It cuts very nicely and has no problem cutting 2 inch thick walnut or bubinga. Cuts are very nice with the included blade and with the sliding channel you get very accurate cuts. I covered the blade access with tape to improve the dust collection. With the blade access covered you get very good dust control when attached to a separate vacuum. I had no problem attaching the hose from my shop vacuum, it fit right into the port that came with the saw. However, the fit will depend on the vacuum you have so it is possible you may need to buy an adapter.

Amazing accuracy while being safer and easier to use than my table saw for cutting panels. As good as everyone says!